Abstract:Track structures are apt to generate degradation under repeated loading of train traffic. Avariation of support stiffness is one of the main degradations, such as unsupported sleepers and the transition position from embankment to a bridge, which occurred frequently. The service performance of track will decline including the comfort index of passengers and the safety of train in these areas. In order to understand the control standard of track stiffness variation, various models have been used to analyze the amplification of dynamic responses of track by researchers. The coupling effect of train and track structure was considered unnegligible in some researches. In this paper, an updated numerical model is developed based on track dynamic theory, in which the CA mortar and concrete base are both taken into consideration. The results were compared with the finite element model ( FEM) results based on ABAQUS software, in which the train loads are assumed as a series of constant loads. From the comparison, the influence of train-track interaction was presented. When the track has no irregularity or degradation, the wheel-rail contact loads are nearly constant, and the dynamic responses of track structure are the same in these two models. But if there are track stiffness variations,the results in train-track interaction model are larger than that in FEM,which means that the train-track interaction has an intensive effect. Besides the differences of track responses, the FEM cannot reveal the variation of contact forces and train responses, which are also essential to summarize the control standard of track degradation. At last, based on the train-track interaction model, various conditions of track stiffness variation are analyzed and discussed.

Load-deflection relations of T-section rails under lateral loads

Load-deflection relations of T-section rails under lateral loads | Charakterystyki obcia̧żeniowo-odksztalłceniowe szyn o przekroju teowym poddanych obcia̧żeniom poprzecznym

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Load-stroke Model for Straightening the Warpage of T-rail

Model of Straightening T-rail Based on Elastic-Plastic Theory

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Two-dimensional Bending Springback Analysis and Test of T-rail

Residual Stress Distributions in Elevator Guide Rail Straightening

Modeling, simulation and experiment for straightening lateral bending of elevator guide rail

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

The elastic buckling of frame columns considering the effect of the shear deformations

Contact Behavior Between Rail and Elastic Foundation

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

On stress and deformation accumulation of continuously welded rails under cyclic thermal loading in high-speed railways

Analysis of Wheel/Rail Contact Stresses and Rail Corrugation

Influence of material properties on the high-speed wheel-rail rolling contact behaviour

Analysis of fatigue crack propagation in rails under combined action of wheel load and residual stress

An elastic-plastic theoretical analysis model of wheel-rail rolling contact behaviour

Three-dimensional elastic–plastic stress analysis of wheel–rail cyclic rolling contact using finite element method

Longitudinal resistance characteristic of rail fastener considering the vertical load 박상준