Abstract:This paper made a revisit on the contact behavior and application of a beam (rail) on a half-plane/half-space. It is found that when the beam is subjected to a concentrated force, the shear deformation of the beam must always be considered, because the deformation only occurs within a limited length of the beam. The second finding of this paper is that the reactions and the surface settlements of the half-plane/half-space are significantly affected by the load position on the cross-section of the beam (on the top of rail in the concerned areas of application) and must be considered in practice. The Flamant/Boussinesq solutions are used to establish integral equations for the surface settlement of the half-plane/half-space below the beam. The Fourier Transform is applied to the first derivative of these integral equations and to the differential equations of the Timoshenko beam. Solving these two equations and employing the inverse Fourier Transform, the deflection and the reaction can be obtained in a compact format. After dispersing the wheel pressure on top of the rail to the centroid, the deflection and reaction are in agreement with the finite element analysis. Finally, simplified equations for equivalent bearing lengths are proposed. Nonuniform distribution of the reactions along the width of the beam is treated by using an equivalent uniform width. If the shear deformation is ignored, the problem becomes the classic one solved by Biot (J Appl Mech 4:A1–A7, 1937). Compared with Biot solution, the current way of solution is compact, their minor differences are the characteristic length. The current solution is a fourth root while the Biot solution is a cube root.

STUDY ON SOME KEY PROBLEMS RELATED TO CRANE BEAM-RAIL SYSTEM UNDER WHEEL PRESSURE

Revisiting the Bearing Stresses in Webs of Crane Runway Girders under Wheel Loads

AN INSIGHT INTO FORMULAS FOR PREDICTING THE LOCAL BEARING STRESS IN WEBS OF CRANE RUNWAY BEAMS

Computation of Local Bearing Stress in Web of Beams Supporting Overhead Cranes

Elastic Buckling of Web Plates in I-girders under Patch and Wheel Loading

Analysis on Bearing Capacity of Rigid Frame Column when Horizontal Knee-braces at Ends of Crane Beams

Analytical Theory of Composite Beams with CSWs Using the State Space Method

LOCAL BUCKLING OF I-SECTIONS IN COMPRESSION AND BENDING

Elastic Stability of Two-Span Continuous Beams under Moving Loads

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Contact Behavior Between Rail and Elastic Foundation

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

On stress and deformation accumulation of continuously welded rails under cyclic thermal loading in high-speed railways

Numerical and experimental investigation on critical stresses due to rail cant

Numerical Analysis and Photoelastic Experiment for the Joint Structure in the Rigid Frame Bridge with Continuous Beam

Elastic Web Buckling Stress and Ultimate Strength of H-Section Beams Dominated by Web Buckling

Analysis of fatigue crack propagation in rails under combined action of wheel load and residual stress

Stress distribution of orthotropic steel bridge decks under vehicle wheel loading

Research on Load Characteristics of Axle-Box Bearing Raceway under Wheel-Rail Excitation

Effects of welding residual stresses on fatigue reliability assessment of a PC beam bridge with corrugated steel webs under dynamic vehicle loading