Abstract:The conventional method (CM) for shear lag analysis of thin-walled box girders supposes that the neutral axis coincides with the centroidal axis of the whole cross section, and thus neglects the axial equilibrium condition. An analytical method considering axial equilibrium and shear deformation, which is referred to as PM, is proposed for overcoming the defect of the conventional method. The longitudinal displacement of the web is introduced to satisfy the axial equilibrium condition and locate the neutral axis automatically. The shear deformation is considered according to the Timoshenko beam theory. Three independent shear lag functions are adopted for describing different shear lag intensities of the top, bottom and cantilever slabs. The governing differential equations for the displacement variables are deduced by means of the virtual work theorem and solved with the relevant boundary conditions. The analytical solution is then derived for the distance from the neutral axis to the top fiber of the cross section. The accuracy of the proposed method is validated by comparisons with the available experimental data as well as the finite element analysis results. Moreover, the distances from the neutral axis to the top fiber, axial forces, and stress difference ratios are analyzed for typical thin-walled box girders to quantify the influence of the axial equilibrium condition. Finally, an extensive parametric study is conducted to examine the effects of various geometric parameters on the stress difference ratio under different load types. The results show that the proposed method can provide good predictions for both deflections and axial stresses, and neglecting axial equilibrium leads to considerable underestimations of axial stresses especially at the top flange-web junctions over the interior support of the continuous box girder.

Revisiting the Bearing Stresses in Webs of Crane Runway Girders under Wheel Loads

AN INSIGHT INTO FORMULAS FOR PREDICTING THE LOCAL BEARING STRESS IN WEBS OF CRANE RUNWAY BEAMS

Computation of Local Bearing Stress in Web of Beams Supporting Overhead Cranes

STUDY ON SOME KEY PROBLEMS RELATED TO CRANE BEAM-RAIL SYSTEM UNDER WHEEL PRESSURE

RATIONAL DESIGN OF CRANE RUNWAY GIRDERS

Finite element analysis on shear capacity of the corrugated web H-shaped steel beam

Shear resistance of slender webs in I-girders

Elastic Buckling of Web Plates in I-girders under Patch and Wheel Loading

Elastic Stability of Two-Span Continuous Beams under Moving Loads

Analysis on Bearing Capacity of Rigid Frame Column when Horizontal Knee-braces at Ends of Crane Beams

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Study on the natural frequency of box girders with corrugated steel webs

Improved method for shear lag analysis of thin-walled box girders considering axial equilibrium and shear deformation

Shear Strength of Trapezoidal Corrugated Steel Webs for Horizontally Curved Girder Bridges

Crack Width Calculation Methods of Reinforced Concrete Bridges and Application of Box Girder Bridge

Contact Behavior Between Rail and Elastic Foundation

STRESS CHECK CALCULATION AND REINFORCEMENTS TREATMENT OF LARGE TONNAGE STEEL CRANE BEAMS UNDER RAIL ECCENTRIC LOADING

Analysis of Transverse Internal Force in Deck of Box Girder with Corrugated Steel Webs under Wheel Load

EXPERIMENTAL RESEARCH ON AND CALCULATION OF SHEAR DEFLECTION FOR TROUGH GIRDERS WITH CORRUGATED STEEL WEBS

Local Bearing Capacity of Steel Beams with Corrugated Webs

Finite Element Analysis and Reinforcement of Steel Crane Beam under Eccentric Track Loading