Abstract:This paper is concerned with the design of bracing systems for three-ribbed parabolic arch bridges against out-ofplane buckling. Typical bracing systems for the three-ribbed arch bridges include K-bracing system and X-bracing system as well as transverse bracing system. The buckling criterion of the braced funicular three-ribbed arch bridge is derived from an exact matrix stiffness method (MSM) with a 14 x 14 s-order element stiffness matrix of three-dimensional beam-column elements that allows for torsional and warping deformations. The lateral torsional buckling load and mode are given by the lowest eigenvalue and eigenvector associated with the assembled structural stability stiffness matrix. A comparison study between different bracing system configurations suggests that the three-ribbed arches with the integral K- or X-bracing system (a K/X-bracing across the three arch ribs) have lower lateral torsional buckling loads than their arch counterparts with the independent Kor X-bracing system (the adjacent arch ribs are connected by K/X-bracing respectively), because the latter ones could provide more restraint on the middle arch rib to avoid early lateral torsional instability. Further, a bracing utilization efficiency index (defined as the normalized buckling capacity over material usage for bracing system) is proposed to quantify the effect of bracing systems in improving the lateral torsional buckling capacity of arch bridges. Highly efficient bracing systems that maximize the lateral torsional buckling load of three-ribbed arch structures with the lowest bracing material usage are then recommended.

Out-of-plane stability of simply supported beams with knee braces

Analysis on Bearing Capacity of Rigid Frame Column when Horizontal Knee-braces at Ends of Crane Beams

Elastic Buckling of Inter-Braced Parallel Beam Systems

Determination of buckling mode for elastic-plastic braced frames

STRENGTH REQUIREMENTS ON KNEE-BRACES OF RAFTERS IN PORTAL FRAMES

Behavior and Design Approach of Knee-Braced Frames

Bracing Systems for Three-Ribbed Arch Bridges Against Out-of-plane Buckling

Buckling of Flexural-Shear Bracing System and Its Braced Steel Frames

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

OUT-PLANE BUCKLING OF TAPERED BEAM-COLUMNS

Determination of Buckling Mode for Braced Elastic–plastic Frames

A simplified analysis on elastic plastic stability of flexural bracing-frame system

Elastic Stability of Two-Span Continuous Beams under Moving Loads

Analytical Study On Buckling Restrained Braced Composite Frames

Buckling of Frames Braced by Flexural Bracing

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Optimal Bracing System Design for Funicular Twin Arches Against Out-of-plane Buckling

An Analysis of Current Stability Theories for Thin-Walled Members

Elastic flexural-torsional buckling of thin-walled cantilevers

Lateral Buckling of Simply Supported C- and Z-Section Purlins with Top Flange Horizontally Restrained

Buckling of laterally and torsionally braced beams