Abstract:In prefabricated buildings, lateral-distortional buckling (LDB) of I-section steel beams is a common failure mode that has garnered considerable attention. However, existing studies and design methods for lateral-distortional buckling primarily focus on members subjected to in-plane flexure and do not take into account the influence of shear forces. In this paper, a study on the elastic lateral-distortional buckling behavior of I-section steel beams under in-plane shear loads was conducted. Firstly, refined finite element (FE) models of beam webs under shear loads were established and validated against theoretical formulas for different boundary conditions. Subsequently, by combining with analytical solutions and numerical results, an accurate buckling load formula for the beam web with a free bottom edge was obtained, which can be used for further study. Based on the parametric analysis results, a formula was obtained to determine the critical flexural stiffness ratio of flange to web. When the flexural stiffness ratio exceeds the critical value, the lateral-distortional buckling of I-section steel beams can be effectively avoided. Finally, a formula that incorporates both the critical flexural stiffness ratio and the span to height ratio was proposed to calculate the elastic critical lateral-distortional buckling loads of I-section steel beams solely under in-plane shear loads.

Elastic Buckling of Inter-Braced Parallel Beam Systems

Out-of-plane stability of simply supported beams with knee braces

Buckling of Flexural-Shear Bracing System and Its Braced Steel Frames

A New Derivation of the Buckling Theory of Thin-Walled Beams

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

Elastic flexural-torsional buckling of thin-walled cantilevers

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

Elastic Stability of Two-Span Continuous Beams under Moving Loads

Flexural–torsional buckling of thin-walled beam members based on shell buckling theory

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Vibration and buckling of a double-beam system under compressive axial loading

Buckling of laterally and torsionally braced beams

Flexural-torsional Elastic Buckling of Tapered Beams with Simple Support

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

ELASTIC BUCKLING OF SIMPLY SUPPORTED RECTANGULAR PLATES UNDER BENDING,SHEAR AND BEARING STRESSES

Buckling of Frames Braced by Flexural Bracing

Elastic Flexural-Torsional Buckling of Doubly Symmetric Web-Tapered I-Beams

The elastic buckling of frame columns considering the effect of the shear deformations

The elastic buckling of interbraced girders

Determination of buckling mode for elastic-plastic braced frames

Analytical solution for fixed-end orthotropic beams subjected to uniform load