Abstract:This paper made a revisit on the contact behavior and application of a beam (rail) on a half-plane/half-space. It is found that when the beam is subjected to a concentrated force, the shear deformation of the beam must always be considered, because the deformation only occurs within a limited length of the beam. The second finding of this paper is that the reactions and the surface settlements of the half-plane/half-space are significantly affected by the load position on the cross-section of the beam (on the top of rail in the concerned areas of application) and must be considered in practice. The Flamant/Boussinesq solutions are used to establish integral equations for the surface settlement of the half-plane/half-space below the beam. The Fourier Transform is applied to the first derivative of these integral equations and to the differential equations of the Timoshenko beam. Solving these two equations and employing the inverse Fourier Transform, the deflection and the reaction can be obtained in a compact format. After dispersing the wheel pressure on top of the rail to the centroid, the deflection and reaction are in agreement with the finite element analysis. Finally, simplified equations for equivalent bearing lengths are proposed. Nonuniform distribution of the reactions along the width of the beam is treated by using an equivalent uniform width. If the shear deformation is ignored, the problem becomes the classic one solved by Biot (J Appl Mech 4:A1–A7, 1937). Compared with Biot solution, the current way of solution is compact, their minor differences are the characteristic length. The current solution is a fourth root while the Biot solution is a cube root.

Elastic Stability of Two-Span Continuous Beams under Moving Loads

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

Steady-state Response of Infinite Beam on Kelvin Foundation under Moving Loads

Revisiting the Bearing Stresses in Webs of Crane Runway Girders under Wheel Loads

Out-of-plane stability of simply supported beams with knee braces

AN INSIGHT INTO FORMULAS FOR PREDICTING THE LOCAL BEARING STRESS IN WEBS OF CRANE RUNWAY BEAMS

A Comparative Study of Alternative Approaches for Stability Design of Steel Frames

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Elastic Buckling of Inter-Braced Parallel Beam Systems

Computation of Local Bearing Stress in Web of Beams Supporting Overhead Cranes

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Analytical solution for fixed-end orthotropic beams subjected to uniform load

Flexural-torsional Elastic Buckling of Tapered Beams with Simple Support

Vibration and buckling of a double-beam system under compressive axial loading

Elastic flexural-torsional buckling of thin-walled cantilevers

Applicability of Effective Tangent Modulus Method in Evaluation of Buckling Strength of Long-Span Cable-Stayed Bridges

Analysis on Bearing Capacity of Rigid Frame Column when Horizontal Knee-braces at Ends of Crane Beams

Inelastic Storey-Buckling Factor of Steel Frames

STORY-BASED ELASTIC-PLASTIC STABILITY COEFFICIENTS OF FRAMES

Contact Behavior Between Rail and Elastic Foundation

Transfer matrix method for analyzing dynamic response of multi-span elastically supported SFT under moving load