Abstract:Planar steel plates have many advantages, including high precision, flexible outline shape fabrication, and convenient transportation and storage, which make them suitable for various steel structures (e.g., reticulated shell structures). However, the steel plates are not commonly used as structural members, because they have a relatively low out-of-plane flexural stiffness. To improve the flexural buckling resistance, a novel type of built-up plate member comprising two longitudinal plates is proposed in this study. Additionally, the flexural buckling behavior of the novel built-up members is investigated. A series of compression tests on 42 specimens of built-up plate members is conducted to determine the elastic and ultimate critical loads. Flexural buckling about the minor axis is observed to be the failure mode of the specimens. The equivalent slenderness ratio method is used to determine the theoretical elastic critical loads of the specimens. With consideration of the measured material properties, geometric imperfections, and residual stresses of the specimens, a refined finite-element model is developed to simulate the flexural buckling behavior. Furthermore, the applicability of two representative specifications (American and European) to the novel built-up member is discussed. The results indicate that the design strengths calculated using these specifications are generally conservative for determining the ultimate loads of the built-up plate members. Design curve “c” in Eurocode 3 is found to be the most suitable among the specifications of interest for determining the design strength. This study provides valuable guidance for the design of built-up plate members.

LOCAL BUCKLING OF I-SECTIONS IN COMPRESSION AND BENDING

Elastic Buckling of Web Restrained by Flanges in I-section Members

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER AXIAL COMPRESSION

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER BENDING

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

ELASTIC BUCKLING OF SIMPLY SUPPORTED RECTANGULAR PLATES UNDER BENDING,SHEAR AND BEARING STRESSES

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

A unified analysis for distortional and lateral buckling of C-purlins in flexure

LOCAL AND DISTORTIONAL BUCKLINGS OF DIFFERENT INCLINED LIPPED PURLINS

ELASTIC SHEAR BUCKLING OF WEB PLATES IN TAPERED I-GIRDERS

Elastic Flexural-Torsional Buckling of Doubly Symmetric Web-Tapered I-Beams

A New Derivation of the Buckling Theory of Thin-Walled Beams

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

STUDY ON LOCAL BUCKLING OF WEBS OF COMPOSITE BEAMS SUBJECTED TO POSITIVE BENDING MOMENT

Local Buckling Analysis of Aluminum I Section Beams

An Interactive Buckling Theory for Built-Up Beam-Columns and Its Application to Centrally Compressed Built-Up Members

Local Buckling Tests on Cold-Formed Steel Beams

RESEARCH ON LOCAL BUCKLING OF DODECAGONAL SECTION DOUBLE SKINNED CONCRETE-FILLED STEEL TUBE SHORT COLUMN

Buckling of Piecewise Member Composed of Steel and High-Strength Materials in Axial Compression