Abstract:The outstand flanges of aluminium alloy angles are sensitive to local buckling due to the low elastic modulus of material. To improve the sectional buckling stress, lips could be introduced to improve the stability behaviour of the outstand flanges. This paper presents an equilibrium approach and a simplified energy method for the local and distortional buckling of extruded aluminium alloy lipped angle columns. Closed form solutions for local buckling and distortional buckling are proposed. The equivalent flexural rigidity and torsional rigidity of the lip are two main factors affecting the sectional buckling behaviour. As distinct from double-sided symmetrical edge stiffeners, the bending of a single-sided edge stiffener can lead to in-plane compressive deformation of the adjacent flange. Based on the edge-stiffened flange model, the equivalent flexural rigidity of the lip is obtained from finite element (FE) analysis. To validate the proposed analytical methods, the elastic buckling coefficients of lipped angles with varying dimensions are obtained from eigenvalue buckling analysis. Lips of different thicknesses are considered to study the effect of torsional rigidity. Comparing with FE results, the proposed equilibrium approach shows excellent accuracy for both local and distortional buckling stresses. The closed form solution given by energy method can also well predict the sectional buckling stress. Finally, parametric studies are carried out to further investigate the effects of flexural and torsional rigidities of lips and the slenderness ratios of flanges on the elastic buckling behaviour. Some design remarks are concluded to provide valuable reference for the application of extruded aluminium alloy lipped angles in practice.

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER AXIAL COMPRESSION

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER BENDING

LOCAL AND DISTORTIONAL BUCKLINGS OF DIFFERENT INCLINED LIPPED PURLINS

Distortional and Lateral Buckling of Z-Purlins with Sloping Lips in Flexure

Local and Distortional Buckling of Extruded Aluminium Alloy Lipped Angle Columns

LOCAL BUCKLING OF I-SECTIONS IN COMPRESSION AND BENDING

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

Lateral Buckling of Simply Supported C- and Z-Section Purlins with Top Flange Horizontally Restrained

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

ELASTIC FLEXURAL-TORSIONAL BUCKLING OF C-PURLIN AND Z-PURLIN

Elastic Buckling of Web Restrained by Flanges in I-section Members

Elastic flexural-torsional buckling of thin-walled cantilevers

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Experimental Investigation on Nested Continuous Z-purlins under Gravity Loading

ELASTIC BUCKLING OF SIMPLY SUPPORTED RECTANGULAR PLATES UNDER BENDING,SHEAR AND BEARING STRESSES

LATERAL-TORSIONAL BUCKLING OF C-SECTION COLD-FORMED PURLINS WITH TWO ANTI-SAG BARS

ANALYSIS OF TWISTING ABOUT UPPER FLANGE OF C-SECTION PURLIN WITH TWO SAG RODS

Local Buckling Tests on Cold-Formed Steel Beams

Buckling study of lipped-H section members