Buckling study of lipped-H section members

E. N. Zhang,Yanlin Guo

2007-01-01

Abstract:A lipped-H section member, as an innovation thin-walled section, is put forward and studied. It can be used in both portal rigid frames and large span roofs as perlins. The 'lip' r efers to a stiffener in the form of a right-angled lip formed at the free edge of the flange of H section. The primary function of the lip is to economically enhance the local buckling of an open thin-walled H section. This paper presents a linear-elastic stability analysis of lipped-H section members subjected to uniform compression. The interactive behavior of the flange plate and lips is extremely complex. Important differences in behavior occur according to the magnitude of lip width. In this paper, eigen-value method is used to obtain buckling modes and buckling stresses. The boundary conditions of the members are pinned at two ends. A finite four-node shell element provided by ANSYS software package is employed to investigate to its buckling behavior. A great amount of numerical studies have been carried out with various geometrical parameters. The parameters investigated are: slenderness ratio, the section aspect ratio, the thickness ratio of flange to web and the width ratio of lip to flange. Compared with H section members, lipped-H section members have different buckling modes and buckling stresses; particularly for lipped-H section members distortional buckling occurs. Figure 1, 2 and 3 respectively show sectional deformed configuration when local buckling, distortional buckling and global buckling occur. It is also found that lips can greatly improve the local buckling stress of flanges and an optimum width ratio of lip to flange is obtained based on numbers of numerical results.