Abstract:Advances in Structural Engineering, Ahead of Print. In the engineering structures using circular steel tube (CST), the eccentric loading of CST members often occurs due to installation error and structural form. Existing research mainly focuses on the bearing resistance of circular steel pipes under the condition of eccentricity at one end. In practical application, both ends of CST members also may be eccentric. And with the increase in eccentricity, material yielding may occur prior to flexural buckling. So far, it's lack of reports about the mechanical behavior of CST members subjected to eccentric loading at both ends and the boundary between material yielding and flexural buckling. This paper presents experimental, numerical and theoretical studies on bearing resistance of thin-walled circular steel tube with slenderness ratio of 30, 40 and 50, subjected to eccentric loading at one end and both ends, respectively. The study reveals a significant discrepancy in the prediction of bearing resistance for circular tubes subjected to eccentric loading at both ends according to existing design codes. Considering the synthesis of bending moment and deflection caused by eccentric loading at both ends, the calculation method of the bearing resistance based on flexural buckling of CST is established, which enhances the prediction accuracy of test verification. In addition, a theoretical boundary between the two failure modes appearing in CST members under eccentric loading at one and both end(s) - flexural buckling and reaching the material yielding strength - was established as dominated by the slenderness ratio and loading eccentricity.

A Method of Constitutive Experiment for Accurate Description of Tube Performance under Rotary-Draw Bending

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Springback Prediction Model Considering the Variable Young’s Modulus for the Bending Rectangular 3A21 Tube

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Seismic Behavior of Steel Tube Confined RC Columns under Compression-Bending-torsion Combined Load

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Theoretical and Experimental Study on Load-Carrying Capacity of Combined Members Consisted of Inner and Sleeved Tubes

Springback prediction of titanium tube bending considering Bauschinger effect and Young's modulus variation

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Push-bending Process of Stainless-Steel Tubes: Experiment and Simulation

Numerical Simulation of Distortion of Rectangular Tube with Multi-Point Stretch Bending

Springback law of high-strength 21-6-9 stainless steel tube in numerical control bending under different process parameters

Bending deformation behavior and characterization method of flexural stiffness of composite tubes under four-point bending tests

Study of the Behavior of Square Concrete-Filled CFRP Steel Tubular under a Bending-Torsion Load

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

Implicit elastoplastic finite element analysis of tube-bending with an emphasis on springback prediction

Investigation on bearing resistance of thin-walled circular steel tube subjected to eccentric loading