Abstract:This paper reports a study on the mechanical behaviour of tapered concrete-filled double skin steel tubular (CFDST) members under bending. A total of twelve specimens with diverse hollow ratios and shear span ratios were tested. The failure mode, the distribution of the deflection curves, the bending moment-curvature curves (M-φ), the longitudinal stress distribution of the cross-section and the strain were investigated, respectively, to understand the bending performance and working mechanism of the specimens. Meanwhile, the finite element (FE) models of tapered CFDST members were developed to investigate the flexural behaviour by ABAQUS software. Finally, the calculation method for predicting the flexural capacity of tapered CFDST members was proposed. The results show that tapered CFDST specimen fails in a very ductile manner and no tensile fracture is observed at the tension region. The maximum deflection of tapered CFDST members occurs at the 3/4L0 section. Moreover, it is found that the flexural capacity is sensitive to the change of taper angle and hollow ratio due to the variation of flexure stiffness. For instance, ultimate bending capacity can be decreased by 62.6% when the taper angle changes from 0° to 1.71°. In addition, it is not reliable to directly select the minimum section of tapered CFDST members as designed section, which will underestimate the flexural capacity of the specimens. Therefore, the concept of equivalent section is proposed to predict the calculation, and the predicted results are satisfactorily in accordance with the measured results, which can provide certain reference for engineering design.

Bending deformation behavior and characterization method of flexural stiffness of composite tubes under four-point bending tests

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubes under Bending

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Experimental and Analytical Study of Hollow Section Concrete-Filled GFRP Tubes in Bending

Study of the Behavior of Square Concrete-Filled CFRP Steel Tubular under a Bending-Torsion Load

Compressive Tests of Thin-Walled Circle Concrete-Filled Steel Tubes

A Method of Constitutive Experiment for Accurate Description of Tube Performance under Rotary-Draw Bending

Flexural behavior of circular concrete-filled steel tube members reinforced with annular stiffener

Flexural behavior of steel tube confined concrete members under pure bending

Research on mechanical behaviour of tapered concrete-filled double skin steel tubular members with large hollow ratio subjected to bending

Mechanical properties of concrete filled steel tube members constrained by carbon fiber reinforced materials under bidirectional coupled loading

Prediction of nonlinear mechanical characteristics for metallic strip flexible pipe with bend stiffener constraints

Tests on pure bending mechanical performance of steel tube confined high-performance concrete

Experimental Research on Pure Bending Beams of Square Concrete Filled Tubes with Composite Section

Full-Cross-Section Deformation Characterization of Cu/Al Bimetallic Tubes under Rotary-Draw-Bending Based on Physics-Driven B-Spline Curves Fitting

Analytical behavior of circular concrete-filled thin-walled steel tubes subjected to bending