Abstract:During manufacturing thin-walled tubes using free bending forming (FBF) technology, defects such as wrinkling, cracking, and cross-section distortion are easy to exist due to various forming parameters' direct and indirect influence, which seriously influences the forming quality of the rectangular tubes. Thus, in this study, the finite element (FE) modeling of thin-walled AA6061-T6 rectangular tubes manufactured by FBF technology was accomplished and verified through experimentation. Moreover, the influence of different parameters on the deformation behavior of the rectangular tubes was systematically investigated using FE modeling. The results showed that the maximum thickness changing rate and the cross-section distortion appeared once the bending die moved to the maximum eccentricity ( U max ). Besides, with the increase of yield strength-Young's modulus ratio ( σ s /E ), thickness ( t 0 ), fillet radius ( R f ), clearance (Δ c ), friction coefficient ( f ), and chamfer radius of the guider ( R c ), the thickness changing rate and the cross-section distortion decrease, while the bending radius enlarges simultaneously when the parameters are set within reasonable limits. Unlike the above parameters, with the improvement of the axial feeding speed ( V f ), the thickness changing rate declines while the fluctuation of bending radius is not significant. Under the joint action of the axial force P L , the structural characterization of the rectangular tube and the dies of constraints, the thinning of the outer wall and the web distortion are inhibited, and the variation amplitude of them is much smaller than that of thickening of the inner wall and flange distortion during the free bending process.

Numerical Simulation of Distortion of Rectangular Tube with Multi-Point Stretch Bending

Numerical Research on High-Strength Rectangular Section Steel Tube in Rotary-Draw Bending

A new multi-step approach considering bending effects and its application in the stretch bending of rectangular tubes

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Mechanical Modeling of Tube Bending Considering Elastoplastic Evolution of Tube Cross-Section

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Numerical and experimental study on in-plane bending of microchannel aluminum flat tube

Study on the Influence of Mandrel Type on Copper Tube Rotary Draw Bending

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

New Method for Finite Element Simulation of Stretch Forming

A Method of Constitutive Experiment for Accurate Description of Tube Performance under Rotary-Draw Bending

Numerical Study on Plastic Strain Distributions and Mechanical Behaviour of a Tube under Bending

Mechanical analysis of finned special-shaped tubes in bending-torsional coupling deformation

Axial Stress Analysis for the Hydro Bending Process of Double-Layered Tube

Study on FEM Numerical Simulation Method for the Welding Distortion

Deformation Behavior of Convolute Thin-Walled AA6061-T6 Rectangular Tubes Manufactured by the Free Bending Forming Technology

Multistep Method in Numerical Simulation of Tube Hydroforming

Study on Formability of Tube Hydroforming Through Elliptical Die Inserts

Effect of die structure parameters on deformation behavior of bent tube in free bending process