Extrusion shaping of bi-functional catalyst for one-step synthesis of dimethyl ether from syngas

Yun-feng WANG,Hong-wei LIU,Hai-tao ZHANG,Wei-yong YING,Ding-ye Fang
DOI: https://doi.org/10.3969/j.issn.1001-9219.2016.06.001
2016-01-01
Abstract:The Cu/Zn/Al2O3 was mixed with pseudo boehmite and extrusion assistants to prepare the shaped bi-functional catalyst for one-step synthesis of dimethyl ether from syngas by extrusion. Through strength measurement, characterization and activity tests of the shaped catalysts, the optimal extrusion shaping conditions were determined as follows: mass ratio of Cu/Zn/Al 2O3 to pseudo boehmite of 1 ∶ 1, peptizer (HNO3) mass fraction of 4%, lubricants citric acid and sesbaria cannabina powder of 5% and 2.5%, respectively, and mass ratio of water to solid material of 0.60. The catalyst shaped at the optimized conditions had a strength of about 153N/cm, and over it, under 250℃, 3MPa and GHSV of 1500mL/(g·h), CO conversion was 79.8% with a DME selectivity of 49.1%and a methanol selectivity of 15.2%.
What problem does this paper attempt to address?