Abstract:A series of HZSM-5 zeolites modified with various mass fractions of antimony oxide Sb2O3(0-30%) were prepared by solid state ion exchange method,and then physically mixed with an industrial methanol synthesis catalyst(XNC-98) to form a series of hybrid catalysts CuO-ZnO-Al2O3+Sb2O3/HZSM-5.The direct synthesis of dimethyl ether(DME) from syngas was carried out over the prepared hybrid catalysts under pressurized fixed-bed continuous flow conditions.The results indicated that over the CuO-ZnO-Al2O3+Sb2O3/HZSM-5 hybrid catalysts with suitable amount of Sb2O3 the selectivities of undesired byproducts hydrocarbons and CO2 were significantly decreased from 9.3% and 32.4% to less than 1% and 28%,respectively,and the selectivity for DME was enhanced greatly from 55% to 69% under temperature of 260℃,pressure of 4 MPa and gas hourly space velocity of 1500 ml/(g·h),compared with that over the unmodified HZSM-5 hybrid catalysts.It was clear from the results of NH3-TPD characterization that the decrease in the formation of hydrocarbons and CO2 could be attributed to the significant decline in the amount of strong acid sites induced by Sb2O3 modification.In addition,the influences of the operating parameters,including the reaction temperature,pressure and space velocity of feed on the catalytic performance of the hybrid catalysts were also investigated.It was shown that at high reaction temperature and high gas hourly space velocity both lower CO conversion and lower DME selectivity were obtained,the suitable reaction temperature and gas hourly space velocity would be less than 280℃ and 3000 ml/(g·h),respectively.

Highly Efficient Synthesis of Dimethyl Ether from Syngas over the Admixed Catalyst of CuO–ZnO–Al2O3 and Antimony Oxide Modified HZSM-5 Zeolite

THE DIRECT SYNTHESIS OF DIMETHYL ETHER FROM SYNGAS OVER THE HYBRID CATALYST WITH ANTIMONY MODIFIED HZSM-5 ZEOLITE AS ACID COMPONENT

Acidity of Magnesium Oxide Modified HZSM-5 Zeolite and Its Application in the Direct Synthesis of Dimethyl Ether from Syngas--The Effect of Magnesium Precursor

Influence of SiO2/Al2O3 ratio in HMCM-22 on catalytic performance of Cu2ZnO2Al2O3/HMCM-22 for synthesis of dimethyl ether

Influence of SiO_2/Al_2O_3 Ratio in HMCM-22 on Catalytic Performance of Cu-ZnO-Al_2O_3/HMCM-22 for Synthesis of Dimethyl Ether

Single-Step Synthesis of Dimethyl Ether from Biomass-Derived Syngas over Cuo-Zno-Mox (M = Zr, Al, Cr, Ti)/Hzsm-5 Hybrid Catalyst: Effects of Mox

Dimethyl Ether Synthesis from Methanol and Syngas over Different Sized HY Zeolite and Cu-Mn-Zn/HY Bifunctional Catalyst

Effects of Ammonium Hexafluorosilicate Modification on Acidity of Hmcm-22 and Catalytic Performance of Cuo-Zno-Al2o3/Hmcm-22 for Dimethyl Ether Synthesis

Study on Catalyst C207-HZSM-5 for Dimethyl Ether Synthesis

Dimethyl Ether Synthesis from CO2 Hydrogenation on a CuO−ZnO−Al2O3−ZrO2/HZSM-5 Bifunctional Catalyst

The Direct Synthesis of Dimethyl Ether from Syngas over Hybrid Catalysts with Sulfate-Modified Γ-Alumina As Methanol Dehydration Components

Synthesis of Dimethyl Ether (DME) on Modified HY Zeolite and Modified HY Zeolite-Supported Cu–Mn–Zn Catalysts

Effect of Modified Zeolite on One-Step Process of DME Synthesis

One-Step Synthesis of Dimethyl Ether from Syngas with Fe-Modified Zeolite ZSM-5 as Dehydration Catalyst

Dimethyl Ether Synthesis Via Methanol and Syngas over Rare Earth Metals Modified Zeolite Y and Dual Cu–Mn–Zn Catalysts

Aluminum Fluoride Modified HZSM-5 Zeolite with Superior Performance in Synthesis of Dimethyl Ether from Methanol

Preparation of Phosphorus-Modified Hzsm-5 Zeolite and Its Application in the One-Step Synthesis of Dimethyl Ether from Syngas

Effect of the Addition of Manganese and Zinc on the Properties of Copper-Based Catalyst for the Synthesis of Syngas to Dimethyl Ether

Highly Effective Conversion of Syngas to Dimethyl Ether over the Hybrid Catalysts Containing High-Silica HMCM-22 Zeolites

Effects of CaO-modified Zeolite on One-Step Synthesis of Dimethyl Ether