Abstract:The direct DME synthesis from syngas was studied by using activated carbon-based bifunctional catalytic beds. Two kinds of activated carbons, prepared by physical (by CO 2 partial gasification) and chemical (with phosphoric acid) activation of olive stones, were used as supports for the preparation of the catalysts. The chemically activated carbon presented a considerable amount of thermally and chemically stable surface phosphorus complexes, which played an important role on the catalytic performance of the prepared catalysts. A Zr-loaded P-containing activated carbon presented a relatively high activity, selectivity and stability for the production of DME from methanol and was used as methanol dehydration catalyst. On the other hand, Cu-Zn was loaded on both P-containing and P-free activated carbon supports for the preparation of methanol synthesis catalysts. The presence of surface-phosphorus on the carbon support resulted in a strong metal-support interaction, hindering the catalytic activity for the hydrogenation of CO to methanol. However, the catalyst that did not contain phosphorus showed noticeable activity for this reaction. The physical mixing of the methanol synthesis and methanol dehydration catalysts resulted in the preparation of carbon-based bifunctional catalytic beds, which performed very efficiently in the direct DME synthesis from syngas in a fixed-bed reactor. Different mass ratios of the individual (metallic and acid) catalysts were studied. An acid/metallic catalyst mass ratio of 2 provided the catalytic bed with enough acid sites to promote methanol dehydration to its maximum extent and make the overall product distribution controlled by the methanol synthesis reaction on the metallic phase.

The Direct Synthesis of Dimethyl Ether from Syngas over Hybrid Catalysts with Sulfate-Modified Γ-Alumina As Methanol Dehydration Components

Dimethyl Ether Synthesis from Methanol and Syngas over Different Sized HY Zeolite and Cu-Mn-Zn/HY Bifunctional Catalyst

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

Surface acidity and the dehydration of methanol to dimethyl ether

Cu–Mn–Al based catalyst for the direct syngas to dimethyl ether conversion

Direct Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

One-step synthesis of dimethyl ether from biomass-derived syngas on CuO-ZnO-Al2O3/HZSM-5 hybrid catalyst: Combination method, synergistic effect, water-gas shift reaction and catalytic performance

Direct synthesis of ethanol from dimethyl ether and syngas over combined H-Mordenite and Cu/ZnO catalysts.

Promoted catalytic performance of sugarcane bagasse ash supported by γ‐alumina as efficient, stable, and ecofriendly catalyst for dehydration of methanol to dimethyl ether

Dehydration of Methanol to Dimethyl Ether over Al2(SO4)3/SiO2 Catalysts

Dimethyl Ether Synthesis from CO2 Hydrogenation on a CuO−ZnO−Al2O3−ZrO2/HZSM-5 Bifunctional Catalyst

Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

Biomass-derived activated carbon catalysts for the direct dimethyl ether synthesis from syngas

Synthesis of Dimethyl Ether Via Methanol Dehydration over Combined Al2o3-Hzsm-5 Solid Acids

DME Synthesis From CO/H<sub>2</sub> over Cu-Mn/Ă-Al<sub>2</sub>O<sub>3</sub> Catalyst

Dme Synthesis From Co/H-2 Over Cu-Mn/Gamma-Al2o3 Catalyst

DME Synthesis From CO/H 2 over Cu-Mn/Ă-Al 2 O 3 Catalyst

Catalytic dehydration of methanol to dimethyl ether over micro–mesoporous ZSM-5/MCM-41 composite molecular sieves

Optimizing CO 2 Hydrogenation to DME through Tailored Interfacial Interactions: Weakening Synergy in CuZnZr and Al-Modified SBA-15 Catalysts

Mechanism and catalytic performance for direct dimethyl ether synthesis by CO2 hydrogenation over CuZnZr/ferrierite hybrid catalyst

Catalysis for One-step Synthesis of Dimethyl Ether from Hydrogenation of CO