Dehydration of Methanol to Dimethyl Ether over Al2(SO4)3/SiO2 Catalysts

杨海霞,孙清,傅玉川,沈俭一
2009-01-01
Journal of Molecular Catalysis(China)
Abstract:The Al2(SO4)3/SiO2 catalysts were prepared via an incipient wetness impregnation method.The physical and chemical properties,in especial the surface acidity of the catalysts were characterized by the techniques of BET,XRD,FT-IR,isopropanol probe reaction,microcalorimetry and FT-IR for NH3 adsorption.The catalytic activities of the catalysts were evaluated in the reaction of methanol dehydration to dimethyl ether.The results from BET,XRD and FT-IR verified that the specific surface areas of the supported catalysts decreased with the increase of Al2(SO4)3 loading.Above 20% Al2(SO4)3 loading,crystalline Al2(SO4)3 was detected for the supported samples.It could be concluded from the results of microcalorimetry and FT-IR for NH3 adsorption,that,upon the loading of Al2(SO4)3,the supported catalysts exhibited much higher surface acidity than the SiO2 support,on which the surface acidity was first enhanced and then weakened with the continuous increase of Al2(SO4)3 loading.In addition,both Brnsted(B) and Lewis(L) acid sites exist on the surface of the supported samples with B acid sites predominantly.The catalyst with 3% Al2(SO4)3 loading exhibited the strongest surface acidity and thus possessed the highest catalytic activity in methanol dehydration.At 533 K,83.5% conversion of methanol with 100% selectivity to dimethyl ether was achieved on the 3Al2(SO4)3/SiO2 catalyst.
What problem does this paper attempt to address?