Abstract:During the cold drawing process, pearlite lamellae turn to the drawing direction to form ferrite fiber texture; the cementite lamellae are divided into a multilayer structure, and the dissolution of cementite lamellae in some regions results in the lattice expansion of ferrite phase and the occurrence of neck‐down regions in the cementite lamellae. The microstructure, texture, and dislocation configuration of cold‐drawn pearlitic steel wires were investigated by scanning electron microscopy (SEM), electron backscattering diffraction (EBSD), and transmission electron microscopy (TEM). In addition, Fe/Fe3C interface structure at the atomic level was clearly observed and analyzed by high‐resolution TEM (HRTEM), and the microscopic deformation mechanism of cementite lamellae at different drawing strains is revealed. The results show that pearlite lamellae turn to the drawing direction to form ferrite fiber texture, and the cementite and ferrite lamellae are simultaneously thinned with the increase of drawing strain. During the cold drawing process, shear‐bands(S‐bands) are formed in the cementite lamellae; the dislocation of ferrite transits from single slip to multi‐slip stage, and the dislocation density increases. After drawing, the lattice structures of cementite and ferrite phases show the evolution from single‐crystal to polycrystal, and the cementite lamellae are divided into a multilayer structure: central relative large‐size cementite crystal and outside relative small‐size cementite crystal layer; the dissolution of cementite lamellae in some regions results in the lattice expansion of ferrite phase and the occurrence of neck‐down regions in the cementite lamellae.

Structure evolution of Cu-3.6% Al2O3 alloy fine wire during cold drawing

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

The effect of cold drawing on the structure, tensile fracture strength and reliability of CuZrAl amorphous microwires

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Achieving Ultrafine Grain Size in Mg-Al-Zn Alloy by Cold Drawing

Evolution of Microstructure and Fe/Fe3C Interface Structure in Cold‐Drawn Pearlitic Steel Wires

Microstructures and properties of cold drawn submicron crystalline Cu-5wt%Cr material

Ductile Chromium in Heavily Cold-Drawn Cu 75 Cr 25 Alloy

Microstructure Evolution, Mechanical Properties and Corrosion Behavior of Biodegradable Zn-2Cu-0.8Li Alloy During Room Temperature Drawing

Tensile strength and Young's modulus of Cu-Ag alloys in the evolution of microstructure into filamentary composites

Morphology Evolution of Two-Phase Cu-Ag Alloys under Different Conditions

Cementite Deformation and Dissolution in a Cold-Drawn Pearlitic Steel Wire

Revealing the Microstructure Evolution Mechanism and Mechanical Responses of a Novel Al–Zn–Mg–Cu Alloy by Hot Deformation Process

The Effects of Cold Rolling and Annealing on the Microstructure Evolution of Ordered C-2000 Alloy during Metallic Wire Preparation

Influences of Fe Content and Cold Drawing Strain on the Microstructure and Properties of Powder Metallurgy Cu-Fe Alloy Wire

Texture Evolution and Plastic Deformation Mechanism of Cold-Drawn Co-Cr-Ni-Mo Alloy

Evolutions of the microstructure and electrical conductivity of Cu-6wt%Ag alloy during drawing strain

Recovery, Recrystallization and Thermal Stability of Submicron Crystalline Cu-5%Cr after Cold Drawing

Microstructure and properties of Cu-Ag alloy prepared by continuously directional solidification

Microstructures, Textures and Mechanical Properties Evolution During Cold Drawing of Pure Mg