Abstract:This research aims to investigate the effect of the exfoliation corrosion exposure time on the mechanical properties, the strength and elongation, of friction stir welded Al–Li alloy type 2195-T8. The exfoliation corrosion test was performed using the exfoliation corrosion (EXCO) solution, based on ASTM G34. The samples were exposed to different exposure times 24, 48, 96, 192 and 384 h. The results showed that both the strength and elongation of the welded specimens—exposed to the exfoliation corrosion tests—were reduced. For example, the samples that were exposed to 384 h, their initial tensile strength and elongation were reduced by 13% and 17% respectively. The degradation process due to the exfoliation corrosion on the tensile strength was divided into three stages: fast (0–96 h: 443.7 MPa-416.3 MPa, the degraded rate was 0.29 MPa/h), steady (96–192 h: 416.3 MPa-413.4 MPa, the degraded rate was 0.03 MPa h−1) and medium rate (192–384 h: 413.4 MPa-386.7 MPa, the degraded rate was 0.14 MPa h−1). For the elongation, in general, the reduction was similar to the style of strength, but with different rates. The TEM images showed that this degradation was due to the dissolution of T1 (Al2CuLi) and S′ (Al2CuMg) phase. Also, the corrosion products and their role of adherence on the surface of the tested specimens were investigated. An empirical equation p-t (mechanical properties-exposure time) was established to calculate the effect of exposure corrosion time on the performance of welded specimens.

INFLUENCE OF TENSILE STRESS ON EXFOLIATION CORROSION AND ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY OF 7075al - ALLOY

The Effect of Applied Tensile Stress on the Exfoliation Corrosion of 7075‐T6 Alloy

ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY OF Al ALLOYS DURING EXFOLIATION CORROSION

Exfoliation Corrosion of Aluminum Alloy AA7075 Examined by Electrochemical Impedance Spectroscopy

Exfoliation Corrosion Susceptibility of 8090 Al-Li Alloy Examined by Electrochemical Impedance Spectroscopy

Electrochemical impedance spectroscopy during corrosion process of 8090 Al-Li alloy in EXCO solution

Investigation of Exfoliation Corrosion of Rolled Aa8090 Al-Li Alloy Using Electrochemical Impedance Spectroscopy

Exfoliation Corrosion of Al-Li Alloy 2090-T6 in Exco Solution: A Study of Electrochemical Noise and Electrochemical Impedance Spectroscopy

Electrochemical Impedance Spectroscopy Analysis on Aluminum Alloys in EXCO Solution

Synergistic Effects of Corrosion and Slow Strain Rate Loading on the Mechanical and Electrochemical Response of an Aluminium Alloy

Effect of heat treatment on strength, exfoliation corrosion and electrochemical behavior of 7085 aluminum alloy

Effect of Shot Peening and Stress on Exfoliation Corrosion of 2E12-T3 Al Alloy

Effect of tensile stress on the corrosion performance of silicone-epoxy coatings on 2024 Al-alloy

Investigating the impact and mechanisms of electromagnetic treatment on stress corrosion performance in 7075 aluminum alloy

CORROSION BEHAVIOR OF SUPER-AUSTENITIC STAINLESS STEEL AL-6XN IN SUPERCRITICAL WATER

Influence of Interfacial Stress Produced by MAO on Electrochemical Corrosion and Stress Corrosion Cracking Behavior in 7075 Aluminum Alloy

Study on the Corrosion Behavior and Numerical Simulation of TC18 Titanium Alloy under Tensile Stress

Enhancing Stress Corrosion Cracking Resistance of Low Cu-Containing Al-Zn-Mg-Cu Alloys by Aging Treatment Control

Fatigue damage evolution and failure of pre‐corroded aluminum alloy 7075‐T651 under air and corrosion environments

Mechanical Behavior Associated with Metallurgical Aspects of Friction Stir Welded Al–Li Alloy Exposed to Exfoliation Corrosion Test

Effect of extrusion process on the stress corrosion cracking resistance of 7N01 aluminum alloy