Abstract:A typical aluminum alloy, AA7075, was immersed in the EXCO solution, and its corrosion properties during different immersion time were measured repetitively using electrochemical impedance spectroscopy technique (EIS). The EIS data a were simulated using equivalent circuit with ZView program. The results show that once the exfoliation occurs, the low frequency inductive loop in the Nyquist plot associated with the relaxation phenomenon of reaction intermediates disappears, and the Nyquist plane is mainly composed of two capacitive arcs in the high frequency range and low frequency range respectively. The former originates from the original corroded surface, while the latter from the newly formed interface by exfoliation corrosion (EXCO). With the increased immersion time, the high frequency capacitance arc decreases gradually, while the low frequency capacitance arc increases gradually. From the beginning of immersion up to 9 hours, charge transfer resistance gradually decreases, illustrating the acceleration of the corrosion rate, whereas the proton concentration decreases steeply, indicating the cathodic process is pre‐dominant. Then the corrosion rate decreases gradually corresponding to the exhausting of proton ions. The results also show that the exfoliation corrosion is developed from pitting corrosion through intergranular corrosion to general corrosion at the end.

Exfoliation Corrosion of Al-Li Alloy 2090-T6 in Exco Solution: A Study of Electrochemical Noise and Electrochemical Impedance Spectroscopy

Electrochemical impedance spectroscopy during corrosion process of 8090 Al-Li alloy in EXCO solution

ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY OF Al ALLOYS DURING EXFOLIATION CORROSION

Investigation of Exfoliation Corrosion of Rolled Aa8090 Al-Li Alloy Using Electrochemical Impedance Spectroscopy

Exfoliation Corrosion of Aluminum Alloy AA7075 Examined by Electrochemical Impedance Spectroscopy

Exfoliation Corrosion Susceptibility of 8090 Al-Li Alloy Examined by Electrochemical Impedance Spectroscopy

Electrochemical Impedance Spectroscopy Analysis on Aluminum Alloys in EXCO Solution

The Effect of Applied Tensile Stress on the Exfoliation Corrosion of 7075‐T6 Alloy

EIS Investigation of the Deposition of Trivalent Chromium Coatings on Al 6063 Alloy

INFLUENCE OF TENSILE STRESS ON EXFOLIATION CORROSION AND ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY OF 7075al - ALLOY

ELECTROCHEMICAL FEATURES OF THE CORROSION OF AN ALUMINUM-LITHIUM ALLOY IN 3.0% NaCl SOLUTION

Exfoliation Corrosion of As-Extruded Mg–1Li–1Ca: the Influence of the Superficial Layer

Electrochemical noises of LC4, LY12 and pure Al in NaCl solution

Electrochemical Noise Analysis of Ly12-T3 in Exco Solution by Discrete Wavelet Transform Technique

Electrochemical Impedance Spectra for the Corrosion of Porous Cu-35mass%Ni-(5,10)mass%Cr Alloys in Molten (0.62li,0.38k)2co3 at 650 °C in Air

Effect of quenching rate on the corrosion mechanism of coarse grain and fine grain layer in 2195 aluminum-lithium alloy extruded plates

Corrosion Behaviour of Ly12 Alloy under Thin Electrolyte Films

REVIEW ON EXFOLIATION SUSCEPTIBILITY OF ALUMINIUM ALLOYS AND QUANTITATIVE MEASUREMENT METHOD

Corrosion Behavior of Two Heat Treatment Al-Zn-Mg-Cu Alloys in Different Intergranular Corrosion Solution

Electrochemical noise features of pure aluminum during pitting corrosion in neutral NaCl solution

STUDY ON THE CORROSION BEHAVIOR OF Ce CONVERSION COATINGS ON Al6061/SiCp COMPOSITES