Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Genetic-Algorithm-Based Optimized Design of Laser Bending Forming of Sheet Metal

Optimization of Laser Cutting Path Based on Local Search and Genetic Algorithm

Parameters Optimization of Tailor Welded Blank Forming Process

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Process Parameters Optimization for Sheet Metal Forming During Drawing with a Multi-Objective Genetic Algorithm

Multi-objective optimization of stainless steel 304 tube laser forming process using GA

Design of an innovative laser-assisted four-point bending forming process for high-stiffened structure of aluminum alloy

Parameter Optimization for Laser Peen Forming on 6005A-T6 Aluminum Alloy Plates to Enhance the Constrained Deformation of Integral Stiffened Plates

Experimental and numerical investigation on laser beam forming of steel sheets

Process Parameters Optimization of Sheet Metal Forming in Drawing Process Based on the Technology of Genetic Algorithm and Artificial Neural Network

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Process and Development of Laser Forming

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

Prediction of bending parameters and automated operation planning for sheet-metal bending orientated to graphical programming

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Density-based topology optimization of multi-condition peening pattern for laser peen forming

Computer-aided process planning system for laser forming: from CAD to part

Optimization Method of Sheet Metal Laser Cutting Process Parameters under Heat Influence

A New Metal-Forming Technique of Micro-Deep Drawing-Laser Dynamic Forming

Experimental investigation, statistical modeling and optimization of laser bending process of perforated sheets