Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Experimental investigation, statistical modeling and optimization of laser bending process of perforated sheets

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Experimental and numerical investigation on laser beam forming of steel sheets

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Experimental Modeling, Statistical Analysis, and Optimization of the Laser-Cutting Process of Hardox 400 Steel

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

On the Laser Forming Process of 6061 Aluminium Alloy Sheets with Angular Segment Irradiating Scheme: A Numerical and Statistical Investigation

Recent Advances in the Laser Forming Process: A Review

Multi-objective optimization of stainless steel 304 tube laser forming process using GA

A comprehensive review of studying the influence of laser cutting parameters on surface and kerf quality of metals

Finite element method–based multi-objective optimization of press-brake bending of sheet metal

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Experimental Investigation of Industrial Laser Cutting: The Effect of the Material Selection and the Process Parameters on the Kerf Quality

Experimental Study on Circular Overhang Circularity and Surface Quality in AlSi10Mg Manufactured by Laser Powder Bed Fusion

Hybrid modeling and optimization of fiber laser hole cutting of austenitic stainless-steel sheets using response surface

Numerical Simulation of Stainless Steel-Carbon Steel Laminated Plate Considering Interface in Pulsed Laser Bending

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Optimization of Kerf Quality During CO2 Laser Cutting of Titanium Alloy Sheet Ti-6Al-4V and Pure Titanium Ti

Optimization Method of Sheet Metal Laser Cutting Process Parameters under Heat Influence

Effects of Laser Scanning Strategy on Bending Behavior and Microstructure of DP980 Steel