Abstract:An active unbalanced vibration compensation scheme with built-in force actuator for a flexible switched reluctance motorized spindle (SRMS) is proposed. The force actuator is a set of windings, which are wound on the stator pole of the switched reluctance motor (SRM). The equivalent unbalance identification method is proposed to indentify online the unbalanced vibration caused by the grinding wheel’s mass imbalance. The equivalent reference unbalance compensation signal is produced by the identification method, which is used to obtain the compensation current of a force actuator, so a controlled, non-contact electromagnetic compensation force on the rotor of the SRMS is produced by the force actuator to compensate the actively unbalanced vibration of the flexible SRMS. The dynamic flexible SRMS is modeled by means of finite element method (FEM). The inductance of main and control windings, the coefficients of the compensation and the unbalanced magnetic pull force are identified by the FEM, and then the active unbalanced vibration compensation scheme for the flexible SRMS is designed in Matlab, in which inductance of main and control windings, the coefficients of the compensation and unbalanced magnetic pull force are obtained by the Look-up table method. The results show that the proposed active unbalanced force compensation scheme has an obvious compensation effect and the coefficients indentified by the FEM have been closer to an actual effect on compensating the unbalanced vibration of the flexible SRMS.

Research on motorized spindle active vibration control based on piezoelectric stack

Modeling And Control Method Study Of Magnetostrictive Micropositioner And Its Application

Dynamic modeling and vibration response analysis of high speed motorized spindle

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

Non-cylinder Holes Precision Machining by Giant Magnetostrictive Components with Sliding Mode Control

Research on Vibration Control of Bearingless Motorized Spindle

Active Control of Milling Chatter Based on the Built-in Force Actuator

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System

Modeling, Identification, and Adaptive Robust Motion Control of Voice-Coil Motor Driven Stages

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

A Built-in Force Actuator for Active Unbalanced Vibration Control of Grinding Wheel

Finite Difference Based Electrical Modeling and Vibration Control Simulation of Piezoelectric Structronic Plate System

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Control of a 3D Piezo-Actuating Table by Using an Adaptive Sliding-Mode Controller for a Drilling Process.

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

The Active Unbalanced Vibration Compensation of the Flexible Switched Reluctance Motorized Spindle

Vibration Analysis of Stepping Piezoelectric Micro-Motor Using Wiggle Mode

Active Vibration Control of Thin Plate Milling Using Piezoelectric Actuator

Active micro-vibration isolation system for adaptive vibration suppression tests using piezoelectric stack actuator

Adaptive backstepping dynamic sliding mode control for maglev turning motor spindle based on limited time preset performance