Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Analysis and Suppression of Rotor Eccentricity Effects on Fundamental Model Based Sensorless Control of Permanent Magnet Synchronous Machine

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

A Control Strategy for the Mitigation of Rotor Vibration in a Three Phase Induction Motor

Harmonic and Fundamental Rotor Resistance Estimation Scheme for Multiphase Induction Motor Based on Nonsinusoidal Supply Control

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

On-line Identification Based Unbalance Vibration Control With Less Regard to Rotor Speed in Active Magnetic Bearings Supporting Rotor System

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

Sideband Vibration Suppression of Interior Permanent Magnet Synchronous Motors for Electric Vehicles under Multiple Operating Conditions

Active Vibration Control of Rotor System by A Magneto-Rheological Fluid Damper

Vibration Control of a Radial Journal Eddy Current Damper on Flexible Rotor Systems

Research on Electromagnetic and Vibration Characteristics of Dynamic Eccentric PMSM Based on Signal Demodulation

A Model-Free Control Method for Synchronous Vibration of Active Magnetic Bearing Rotor System

Research on a Torque Ripple Suppression Method of Fuzzy Active Disturbance Rejection Control for a Permanent Magnet Synchronous Motor

A Vibration Analysis of the Permanent Magnet Synchronous Motor Under the Effect of Proportional Derivative Control

Synchronous Vibration Control In A Flywheel Rotor System Supported By Active Magnetic Bearings