Abstract:Abstract On-line detection and active control of chatter vibration have always been important issues in milling process respectively. To some extent, the signals obtained with sensors determine the performance of on-line detection and active control of chatter. However, due to the characteristics of milling process, the obtained signals are mainly consisted with spindle rotation frequency and its harmonics, and the chatter components are usually submerged by these stable harmonics, imposing negative effects for the detection and active control of milling chatter. Then, it is highly needed to design a real-time filter to filter out the spindle rotation frequency and its harmonics. In this paper, an adaptive filter is designed to filter out the spindle speed related components. Moving average (MR) model and adaptive filter theory is utilized to estimate these periodic components. The influence of filter order and step size factor on the filter characteristics are also analyzed. Considering that the filter order needs to be adjusted under different cutting conditions, which will alter the filter’s performance, an improved adaptive filter is proposed. Experiments are also performed and the experimental results show that, not only the spindle speed related components can be filtered out effectively, but the chatter frequency components are amplified with appropriate initial step factor, which is beneficial for the detection of milling chatter at early stage. Meanwhile, the periodic components caused by the installation error and the other spindle speed related components can be effectively filtered out real-timely, preventing the saturation of actuator caused by these stable components.

Active Control of Milling Chatter Based on the Built-in Force Actuator

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Suppression of Chatter for Precision Hole Boring Based on Variable Structural Stiffness

Milling Chatter Mitigation with Projection-Based Robust Adaptive Controller and Active Magnetic Bearing

Active Damping of Milling Chatter Vibration Via a Novel Spindle System with an Integrated Electromagnetic Actuator

Active Chatter Suppression for Milling Process with Sliding Mode Control and Electromagnetic Actuator

A Built-in Force Actuator for Active Unbalanced Vibration Control of Grinding Wheel

Active Suppression of Milling Chatter with LMI-based Robust Controller and Electromagnetic Actuator

Dynamic modeling and vibration response analysis of high speed motorized spindle

Magnetorheological fluid-controlled boring bar for chatter suppression

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System

Suppress Chatter in Milling of Thin-Walled Parts Via Fixture with Active Support

Active Suppression of Milling Chatter Based on LQR-ANFIS

Investigation on Adaptive Filter for On-Line Detection and Active Control of Chatter Vibration in Milling Process

Dynamic Modeling for Chatter Analysis in Micro-Milling by Integrating Effects of Centrifugal Force, Gyroscopic Moment, and Tool Runout

Controlling harmful milling vibration for robotic milling system based on the optimization of milling posture and spindle speed

The Active Unbalanced Vibration Compensation of the Flexible Switched Reluctance Motorized Spindle

Adaptive Dynamic Cutting Force Control Analysis for Peripheral Milling

Online Chatter Detection for Milling Operations Using LSTM Neural Networks Assisted by Motor Current Signals of Ball Screw Drives