Abstract:Regenerative chatter can reduce machining quality, tool life, and productivity during milling process. In order to control the milling chatter, the stability analysis of milling system is very important. It has been found that variable spindle speed milling and the use of variable-angle tools are effective to control milling chatter. This paper mainly studies the control effect when these two methods are used simultaneously. Firstly, the improved full-discretization method is used to predict the stability of variable spindle speed milling process with variable pitch cutters. And on the basis of stability prediction, the influence of spindle speed modulation parameters on stability is analyzed. Meanwhile, the stability prediction results of down-milling and up-milling operations, different radial immersion ratio and different tooth pitch variation form are compared. The results show that the stability of variable spindle speed milling process with variable pitch cutters is better than that of variable pitch cutters in constant spindle speed milling process. And the improvement of the stability is related to the spindle speed modulation parameters. When the modulation parameters are bigger, the stable cutting area of the stability lobes diagram will be larger. Secondly, in the up-milling operation and the low immersion operation, the variable spindle milling with variable pitch cutters has better stability than the down milling operation and the high immersion operation. Under the condition that the pitch angles vary linearly, the stability is better. Finally, the time domain simulation is performed and the simulation results verify the accuracy of the stability prediction results.

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Suppression of Chatter for Precision Hole Boring Based on Variable Structural Stiffness

Active Control of Milling Chatter Based on the Built-in Force Actuator

Magnetorheological fluid-controlled boring bar for chatter suppression

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Milling Chatter Mitigation with Projection-Based Robust Adaptive Controller and Active Magnetic Bearing

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

Measurement and Analysis of Dynamic Characteristics of Magnetorheological Intelligent Boring Bar

Active Damping of Milling Chatter Vibration Via a Novel Spindle System with an Integrated Electromagnetic Actuator

Stability analysis for milling system with variable pitch cutters under variable speed

Active Suppression of Milling Chatter with LMI-based Robust Controller and Electromagnetic Actuator

Active Chatter Suppression for Milling Process with Sliding Mode Control and Electromagnetic Actuator

Active Suppression of Milling Chatter Based on LQR-ANFIS

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

The Effect of Controllers on the Dynamic Behaviour of a Rotor Supported on Active Magnetic Bearings

Chatter suppression analysis for variable pitch cutter in milling

Chatter stability analysis of variable speed milling with helix angled cutters

Effect of the Cutter Path and the Workpiece Clamping Position on the Stability of the Robotic Milling System

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Stability Analysis of Milling Based on the Barycentric Rational Interpolation Differential Quadrature Method

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed