Abstract:Different pitch parameters of the tool can lead to the changes in the delay of the machining system. A mechanical model of the variable pitch tool is developed by taking the regenerative chatter into account in the machining system with multiple delays. The dynamic differential equations with multiple delays are studied based on the fully discrete method; the Gaussian integral method is used to approximate the state item of the vibration response in the discrete interval, and the periodic and the delay items are linearly approximated to determine the transition matrix of the discrete state in the multiple delays period. The relationship between cutting force coefficients and cutting parameters is defined based on the size effect of the tool-workpiece contact area; a nonlinear model of the cutting force coefficients is presented by the cutting force detection experiment of aluminum alloy milling with the variable pitch tool. The state transition matrix of the multiple delays system is obtained by combining the Gauss full discrete method with the nonlinear cutting force coefficients, and then the effectiveness of the proposed method is verified by analyzing the convergence degree of the eigenvalue of state transition matrix. At the same time, the relationship between cutting parameters and the stability critical of the machining system is analyzed to draw the three-dimensional stability lobe diagram, which makes it clear that the limiting cutting depth of the tool increases about 2–3 times as the cutting width decreases. Combining with a cutting stability experiment of the variable pitch tool, it is verified that the dynamic model with the nonlinear dynamic parameters has higher prediction accuracy of the cutting stability than others. And it is observed that the eigenvalue of changes of the dynamic model is more violently in the low speed region (2000–4000 rpm), which indicates that the stability of the processing system is more sensitive to the cutting depth under the low speed condition, and the vibration reduction performance of variable pitch tools is more significant.

Chatter suppression analysis for variable pitch cutter in milling

Experimental and simulation study on chatter stability region of integral impeller with non-uniform allowance.

Suppression of Chatter for Precision Hole Boring Based on Variable Structural Stiffness

Stability analysis for milling system with variable pitch cutters under variable speed

Stability Analysis of Milling Based on the Barycentric Rational Interpolation Differential Quadrature Method

Chatter stability analysis of variable speed milling with helix angled cutters

Stability Analysis for Milling Process with Variable Pitch and Variable Helix Tools by High-Order Full-Discretization Methods

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Modeling of variable-pitch/helix milling system considering axially varying dynamics with cutter runout offset and tilt effects

Chatter suppression by parametric excitation: Model and experiments

Investigation of variable pitch tool design for chatter suppression in milling of Ti-6Al-4 V: a comparison of simulation and experimental results

An efficient and precise stability analysis method for milling process

Modeling dynamics and stability of variable pitch and helix milling tools for development of a design method to maximize chatter stability

Optimum Selection of Variable Pitch for Chatter Suppression in Face Milling Operations

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Chatter Stability Prediction of Ball-End Milling Considering Multi-Mode Regenerations

Chatter stability analysis and prediction for elliptical ultrasonic vibration-assisted milling process

Stability Prediction of Milling with Periodic Spindle Speed Modulation based on Global Discrete Algorithm

Stability for multiple delays machining system with variable pitch tools considering nonlinear cutting force coefficients

Stability analysis for variable spindle speed milling via the 3rd-order Newton-Cotes method

A Spline-Based Method for Stability Analysis of Milling Processes