Abstract:In order to meet the growing industrial demand of high quality and high efficiency machining, long cutters with larger axial depth of cut are extensively implemented in peripheral milling of deep pockets, grooves, and thin-wall parts. However, due to their high flexibilities, chatter easily occurs during the machining process. It has been demonstrated that milling cutters with variable pitch and/or variable helix angles can mitigate the chatter, which are gaining increasingly important applications. Although this kind of cutters have been studied in some detail in previous research, few studies have focused on the interaction dynamics complicated by actual cutter runout in long tool-part contact zone. This paper systematically studies the dynamics and stability of variable-pitch/helix milling system with long end cutters. The cutters are divided into a series of axial disks, and each axial disk includes several cutting elements which are equal to the number of teeth. Variations of pitch and helix angles, cutter run-outs including radial offset and axial tilt, and mode shapes with the cross terms in the orthogonal direction, are assigned to these cutting elements. The system, involving multiple regenerative delays as well as the axially varying dynamics, is formulated as a matrix form of time-periodic delay differential equation with multi-modal dynamic parameters. An updated cross-axis and cross-point modal testing method is then proposed to obtain the dynamic parameters, which can effectively avoid multiple hits when impacting the cutter with hammer. The stability lobes are predicted in state space by developing an improved semi-discretization method, by which the pitch variations and actual runout effects on stability are investigated. It is shown that the stability lobes differ significantly when the combined effects of cross-axis and cross-point FRFs and actual cutter runout are considered. A series of cutting experiments is conducted to demonstrate the proposed model and method. Results show that these lobes well agree with the experimental results.

Modeling dynamics and stability of variable pitch and helix milling tools for development of a design method to maximize chatter stability

Modelling of the stability of variable helix end mills

Optimum Selection of Variable Pitch for Chatter Suppression in Face Milling Operations

Milling Stability Prediction and Adaptive Chatter Suppression Considering Helix Angle and Bending

Dynamic Modeling for Chatter Analysis in Micro-Milling by Integrating Effects of Centrifugal Force, Gyroscopic Moment, and Tool Runout

Modeling of variable-pitch/helix milling system considering axially varying dynamics with cutter runout offset and tilt effects

Stability analysis for milling system with variable pitch cutters under variable speed

Chatter suppression analysis for variable pitch cutter in milling

Stability Analysis for Milling Process with Variable Pitch and Variable Helix Tools by High-Order Full-Discretization Methods

Investigation of variable pitch tool design for chatter suppression in milling of Ti-6Al-4 V: a comparison of simulation and experimental results

Chatter stability analysis of variable speed milling with helix angled cutters

A New Chatter Stability Criterion in Milling Process Simulation

Prediction of Time-Varying Chatter Stability: Effect of Tool Wear

Stability Analysis of Milling Based on the Barycentric Rational Interpolation Differential Quadrature Method

A Generalized Runge-Kutta Method For Stability Prediction Of Milling Operations With Variable Pitch Tools

Study on the stability for non-uniform helix angle tools in the milling process

A novel chatter stability criterion for the modelling and simulation of the dynamic milling process in the time domain

Chatter stability in robotic milling

An efficient and precise stability analysis method for milling process

Chatter Stability Prediction of Ball-End Milling Considering Multi-Mode Regenerations

Modeling, Analysis, and Removal of Chatter Marks in Flexible Turning