Abstract:The undesired synchronous vibration due to rotor mass imbalance is a main disturbance source in all rotating machinery including active magnetic bearing (AMB)-rotor systems. In the AMB-rotor system, imbalance compensation, which causes the AMB actuators to spin a rotor about its geometric axis, and automation balancing, which spins a rotor about its inertial axis, are two kinds of common control aim for the rotor imbalance control. In this study, the internal relation between the imbalance compensation and the automation balancing is analyzed and a uniform control method is proposed. With the identical control algorithm, the proposed control method can realize the automation balancing or the imbalance compensation, respectively, by switching the controller's junction position in the original control loop. The proposed control method does not depend on the dynamic plant model, because its algorithm is based on the real-time identification for the Fourier coefficient of the rotor imbalance disturbance. In this paper, the process of identification algorithm is given in detail and all the possible junction forms of the controller are illustrated. By the simulations, the identification performances of the control algorithm are compared in the conditions with three variable factors, including the signal noise ratio (SNR), the imbalance phase and the identification delay time. The noise level has considerable influence on the identification precision, but the imbalance phase has little. To prolong the identification delay time will be of benefit to improve the identification precision but slow down the identification process. Experiments, which are carried out on an AMB-rigid rotor test rig, indicate that by switching the junction position of the controller in control loop, both kinds of rotor imbalance control can achieve the good effectiveness. [DOI: 10.1115/1.4005279]

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System

A Built-in Force Actuator for Active Unbalanced Vibration Control of Grinding Wheel

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

The Active Unbalanced Vibration Compensation of the Flexible Switched Reluctance Motorized Spindle

H<sub>∞</sub>/μ Robust Control of Vibration for an Ultra-Precision Grinding Machine

Dynamic modeling and vibration response analysis of high speed motorized spindle

Active Control of Milling Chatter Based on the Built-in Force Actuator

Experimental study on controlling actively wheel unbalance vibration

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

H∞/μ Robust Control of Vibration for an Ultra-precision Grinding Machine

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Auto balance of active magnetic bearings for rotor support system by means of unbalance identification

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

On-line Identification Based Unbalance Vibration Control With Less Regard to Rotor Speed in Active Magnetic Bearings Supporting Rotor System

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed

Active Control of Active Magnetic Bearings for Maglev Flywheel Rotor System Based on Sliding Mode Control

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings