Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

A Built-in Force Actuator for Active Unbalanced Vibration Control of Grinding Wheel

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

The Active Unbalanced Vibration Compensation of the Flexible Switched Reluctance Motorized Spindle

Active Control of Milling Chatter Based on the Built-in Force Actuator

Experimental study on controlling actively wheel unbalance vibration

H<sub>∞</sub>/μ Robust Control of Vibration for an Ultra-Precision Grinding Machine

H∞/μ Robust Control of Vibration for an Ultra-precision Grinding Machine

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Dynamic modeling and vibration response analysis of high speed motorized spindle

On-line Identification Based Unbalance Vibration Control With Less Regard to Rotor Speed in Active Magnetic Bearings Supporting Rotor System

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

Auto balance of active magnetic bearings for rotor support system by means of unbalance identification

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.