Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Research on Vibration Control of Bearingless Motorized Spindle

Dynamic modeling and vibration response analysis of high speed motorized spindle

Analysis on the stiffness of angular contact ball bearings and its effect on the critical speed of a high speed motorized spindle

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

A Built-in Force Actuator for Active Unbalanced Vibration Control of Grinding Wheel

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System

Adaptive backstepping dynamic sliding mode control for maglev turning motor spindle based on limited time preset performance

Radial Force Feedback Control for a Bearingless Induction Spindle Motor

Active Control of Milling Chatter Based on the Built-in Force Actuator

Active Control of Bearing Force Transmissibility for Active Magnetic Bearings-rigid Rotor Systems

Study on Rotor-Bearing Dynamic Performance of a Novel Motorized Spindle Supported by Water-Lubricated Hydrodynamic Spiral Grooved Bearings

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Experimental study on controlling actively wheel unbalance vibration

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Simulation and Experimental Study of Small Hybrid Vibration Spindle