Abstract:In view of energy shortage and high safety requirements,steels with low density,high strength and high toughness have become a hot research topic in material science. A large number of reports show that the Al and other ele-ments alloying can significantly reduce the steel density,and the laminated composite structure greatly improves the toughness of the steel. In this study,based on the introduction of high strength and high toughness steel with equiaxed grains,steel with layered composite and low-density steel at home and abroad,the idea of low density low to medium-al-loy design(4%-12%)of Fe-Al-Mn-C dual phase steel and the micro-laminated control by grain shape pancaking of both high temperature delta-ferrite phase and austenite phase during hot rolling process is proposed,which makes it possible to obtain a alternatively arranged micro-laminated composite steel with low density,high strength and high toughness. It is proved that it is feasible to obtain the dual phase steel with low density(6.5-7.5 g/cm3),micro-laminated,high strength(1 000-1 500 MPa)and high toughness(200-400 J),which breaks the limitation of toughening mechanism of conventional steel with equiaxial grain structure and opens a new research and development approach for the high strength and high toughness steel. At the end of this paper,a thorough study on the low density and micro-laminated du-al phase steel is proposed to understand the relationship between chemical composition,parameters of the micro-laminat-ed structure and the properties of strength and toughness,and to explore the strengthening and toughening mechanism of the new designed low density and micro-laminated dual phase steel,which would indeed open an innovative direction for future research and development on the low density,high strength and high toughness steels.

The Development of Extra-long Steel Blade for Full-speed Unit

Development of Powder Metallurgy High Speed Steel

Degradation Behavior of Microstructures and Mechanical Properties of GTD111 Turbine Blade After Long-Term Service

Numerical Study of a Full Three-dimensional Engineering Design of 1200 Mm Super-long Last Stage Blades

Technology Development of High Toughness and Ultra-heavy Plate Rolled by 400mm Continuous Casting Billet

Optimization Design of Diamond Circular Saw-Blade with Discontinuous Cutting and Uneven Distribution for Cutting Thin-Walled Tubes

Development of a High-Efficiency Z-Form Selector for Single Crystal Blades and Corresponding Grain Selection Mechanism

Developing the Long Rotating Blade for Large Scale Steam Turbines with Modern CAE Software

Research and development of a new hot rolled laminated structure

Analyses of the Single Blade Strength and Calculation of the Circle Blade Dynamic Frequency

Direct Investigation on High Temperature Tensile and Creep Behavior at Different Regions of Directional Solidified Cast Turbine Blades

Dislocations Across Interphase Enable Plain Steel with High Strength-Ductility.

Ultrafine Grained Dual-Phase Martensite/ferrite Steel Strengthened and Toughened by Lamella Structure

Feasibility Study of Microscale Laser Shock Processing Without Absorbing Coating to Improve High-Cycle Fatigue Performance of DZ17G Directionally Solidified Superalloy

Ultrahigh Fatigue Strength of Gradient Nanostructured Plain Steel

The Development of Steel Band Feeding for HSLA Heavy Plates

Investigation into the Direct Laser Forming Process of Steam Turbine Blade

Low-speed Experimental Verification on High-loading Turbine Blade Design Idea

Development and Production of Ultra-High Strength Linepipes With Dual-Phase Microstructure for High Strain Application

Influences of attack angle and mach number on aerodynamic characters of typical sections of extra-long blade in a steam turbine

Microstructure, Tensile, and Fatigue Properties of Large-Scale Austenitic Lightweight Steel