Abstract:This paper describes the extensive Wind Tunnel (WT) linear cascade testing campaign carried out on a constant section turbine blade developed for low subsonic applications. Comprehensive experimental program was designed to determine the aerodynamic behaviour of this blade under a wide range of varying geometrical like Pitch to Chord Ratio, Stagger Angle and Aerodynamic like Reynolds Roughness, Mach number, Incidence angle conditions. In addition to the classical Two-Dimensional (2D) measurements, targeted Three-Dimensional (3D) surveys have been performed to complement the 2D results, allowing to draw supplementary conclusions as to the behaviour of the considered blade in three-dimensions. The performed experiments predominantly covered the transitional and beginning of a fully turbulent flow regime (maximum Re is 2.5 million). Post processing of experimental results were done in view of exploitation and judgment of some key aerodynamic aspects; parameters such as profile section load distribution, loss coefficient and flow deviation angle. Alongside with confirmation of the design targets, a parallel goal pursued in the current WT testing, was to get a more accurate idea as to the predictive capabilities of the employed CFD tools (CFX and MISES) under the basic flow condition generated in the WT. The aim was to get a global picture, as to the level of agreement that can be reached by the used design tools while accounting for the afore-mentioned design, operational variables. The obtained measurement results clearly indicated the success of the design in achieving the pre-set targets. The paper further provides a detailed discussion on the identified discrepancies, measurement versus predictions, of the key parameters at the geometric, aerodynamic design as well as off-design conditions.

Influences of attack angle and mach number on aerodynamic characters of typical sections of extra-long blade in a steam turbine

Numerical Study of a Full Three-dimensional Engineering Design of 1200 Mm Super-long Last Stage Blades

Influence of Attack Angle on Aerodynamic Performance of Turbine Cascades

Effects of Swept Blade on the Aerodynamic Performance of Turbine Cascade

Experiment on Aerodynamic Performance of Turbine Static Cascade with High Aerodynamic Loading

Numerical Study of the Effects of Bowed Blades on Aerodynamic Characteristics in A High Pressure Turbine

Influence Of Swept Wing On Axial Steam Turbine Static Cascade Aerodynamics

Numerical Study of Effects of Mach Number on Aerodynamic Performance of Large Enthalpy Drop Stationary Cascade

Optimization design of typical blade profile of long blade in ultra-supercritical steam turbine

Wind Tunnel Experiments and Numerical Study on Performance Characteristics of an H-type Vertical Axis Wind Turbine in the Spanwise Direction

Research on Aerodynamic Characteristic and Optimal Design of Turbine Cascades with Curved Blades at Different Attack Angles

Experimental Studies on Turbine Static Blade Design Technique

Experimental investigation on the influence of bowed blade in ultra-highly loaded turbine cascade

Low-speed Experimental Verification on High-loading Turbine Blade Design Idea

3D Numerical Investigation on the Aerodynamic Performance of an Air Cooled 4-Stage Turbine

Experimental study on the aerodynamic performance of aft-loading positive-curving blade

Numerical Analysis on the Influence of the Twisted Blade on the Aerodynamic Performance of Turbine

Numerical investigation on bowed blades of large meridional expansion Turbine

Investigations on Aerodynamic Performance of Turbine Cascade at Different Flow Conditions

Effect of Jet Parameters on the Aerodynamic Performance for the Wind Turbine Blade

Wind Tunnel Testing and Modeling Implications of an Advanced Turbine Cascade