Abstract:Air-side heat and mass transfer performance of plain fin-tube heat exchangers at different vacuum degree have been experimentally investigated. In this experiment, influence of air inlet humidity on air-side heat and mass transfer under vacuum environment is studied by controlling vacuum degree and air inlet humidity. Results show that: variation trend of air-side sensible heat transfer coefficient (ha), heat transfer j-factor (jh), mass transfer coefficient (hm) and mass transfer j-factor (jm) are not all time remain the same. Variation trend of ha, jh are the same with increase of vacuum degree when air inlet humidity changes, ha is gradually decreased and jh is gradually increased. Variation trend of hm is opposite with the increase of vacuum degree when the air inlet humidity changes. Under constant air inlet relative humidity conditions, hm is gradually increased. Under constant air inlet moisture content conditions, hm is gradually decreased. However, variation trend of jm is the same with increase of vacuum degree when air inlet humidity changes, both are increased. But slope of jm is greater under constant air inlet relative humidity conditions. Overall heat transfer performance is greatly affected by air inlet humidity changes. Under constant air inlet relative humidity conditions, when air inlet relative humidity increases from 50% to 70% and then to 90%, proportion of latent heat transfer increases from 30.98%∼53.99% to 36.53%∼56.95% and then increases to 44.19%∼64.04% with vacuum degree increases. As proportion of latent heat transfer increases, air-side total heat transfer performance is not obviously reduced. Under constant air inlet moisture content conditions, when air inlet moisture content increases from 15 to 20 g/kg, proportion of latent heat transfer is basically unchanged with increase of vacuum degree, at about 36% and 37%, respectively. So, total heat transfer performance on air side decreases obviously. In order to model air-side heat and mass transfer performance of the complex structure fin-tube heat exchangers, a simplified model is investigated under vacuum environment. Results show that influence of pressure changes on heat and mass transfer based on theory is basically consistent with the results of regression analysis based on experimental results. This study can provide guiding suggestions for the design of heat exchangers under vacuum environment.

Experimental Study of the Lewis Factor of a Flatly and Straightly Finned Tube Heat Exchanger at the Air Side at a Low Atmospheric Pressure

Effect of Environmental Pressure on Heat and Mass Transfer Characteristics for Fin-and-tube Heat Exchangers under Non-Unit Lewis Factor

Air-side Heat Transfer Characteristics under Wet Conditions at Lower Ambient Pressure of Fin-and-tube Heat Exchanger

Effect of ambient pressure on air side heat transfer and flow characteristics of plain finned tube heat exchanger

A Numerical Study of Lewis Factor for Fin-and-tube Heat Exchangers under Dehumidifying Conditions

Research on the air-side thermal hydraulic performance of louvered fin and flat tube heat exchangers under low-pressure environment

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical Study of Fin-and-Tube Heat Exchanger in Low-Pressure Environment: Air-Side Heat Transfer and Frictional Performance, Entropy Generation Analysis, and Model Development

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Heat Transfer and Pressure Drop Correlations for Compact Heat Exchangers with Multi-Region Louver Fins

Air Side Performance of a Novel Lanced Fin and Flat Tube Heat Exchanger

Effect of vacuum environment on air side heat and mass transfer characters of plain fin-tube heat exchangers

Correlation of Flow and Heat Transfer Characteristics for Multi-louvered Fin

Effect of Surface Efficiency on the Thermal Design of Plate-Fin Heat Exchangers with Passages Stack Arrangement

Airside characteristics of heat, mass transfer and pressure drop for heat exchangers of tube-in hydrophilic coating wavy fin under dehumidifying conditions

Test of flow and heat transfer characteristics for offset strip fin

Air-side flow and heat transfer characteristics research and empirical correlations of wavy fins in negative gauge pressure environment

Thermal-hydraulic Performance of Novel Louvered Fin Using Flat Tube Cross-Flow Heat Exchanger

Numerical Investigation Of Effect Of Tube Shape On Air-Side Heat Transfer And Pressure Drop Characteristics Of A Finned Tube Heat Exchanger

Airside Heat Transfer and Friction Characteristics for Enhanced Fin-and-tube Heat Exchanger with Hydrophilic Coating under Wet Conditions

Numerical Simulation of Heat Transfer Characteristics of Finned Tube Heat Exchanger at Different Flow Velocities