Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Influence of Compression-Expansion Effect on Oscillating-Flow Heat Transfer in A Finned Heat Exchanger

Heat transfer of laminar oscillating flow in finned heat exchanger of pulse tube refrigerator

Observation of Heat Transfer in Oscillating Flow Within A Circular Channel

Heat Transfer in Reciprocating Planar Curved Tube with Piston Cooling Application

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

A Comprehensive Empirical Correlation for Finned Heat Exchangers with Parallel Plates Working in Oscillating Flow

Experimental Study on Heat Transfer of Oscillating Flow of A Tubular Stirling Engine Heater

Effects of different working gases on the heat transfer enhancement performance of a heating tube with spiral insert under oscillatory flow

Numerical investigation of heat transfer and pressure drop characteristics on the hot fluid side of the plate-fin precooler under negative pressure conditions

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

Air-side flow and heat transfer characteristics research and empirical correlations of wavy fins in negative gauge pressure environment

Experimental Study of Boiling Heat Transfer and Flow Characteristics in Fin Channels with Variable Cross Section

Performance Investigation of an Innovative Offset Strip Fin Arrays in Compact Heat Exchangers

Numerical studies on heat transfer and pressure drop characteristics of flat finned tube bundles with various fin materials

Evaluation of heat transfer enhancement effect at the hot/cold end of a Stirling engine using performance improvement factor

Numerical Investigation of Wall Heating/Cooling Effect on the Transonic Compressor Performance

Numerical Investigation Of Effect Of Tube Shape On Air-Side Heat Transfer And Pressure Drop Characteristics Of A Finned Tube Heat Exchanger

Effect of fin shapes on flow boiling heat transfer with staggered fin arrays in a heat sink

Complex Turbulent Flow and Heat Transfer Characteristics of Tubes with Internal Longitudinal Plate-Rectangle Fins in EGR Cooler

Numerical simulation on heat transfer enhancement of free piston Stirling engine heater with composite cross section mini channels