Abstract:The heat and mass transfer characteristics of a flatly and straightly finned tube heat exchanger were tested in a simulation cabin with an environment having a high altitude and low atmospheric pressure to investigate the variation law of the Lewis factor and its influencing factors at various ambient pressures.On this basis,a pressure correction factor was introduced to predict the Lewis factors at various ambient pressures.The test results indicate that when the ambient pressure drops from 101.3 kPa to 40 kPa,the Lewis factor will vary notably,the maximum decrement hitting 22.2％ and the maximum increment reaching 53.7％.When the surface of fins on the tubes of the heat exchanger is partially wet,the moisture content of air at the inlet will have a relatively big influence on the Lewis factor.When the surface of fins on the tubes of the heat exchanger is wholly wet,the moisture content of air at the inlet will have an inconspicuous influence on the Lewis factor.With a drop of the ambient pressure,the surface of the fins on the tubes of the heat exchanger will transit from the partial wet to the wholly wet.Before the transition,the Lewis factor will decrease with a drop of the ambient pressure and after the transition,the Lewis factor will increase with a drop of the ambient pressure.After a pressure correction factor had been introduced,the correlation formula can predict relatively well the Lewis factor at various ambient pressures and the relative errors between the values calculated by using the correlation formula and 99％ of the test data are within a range of ± 20％.

Heat Transfer and Pressure Drop Correlations for Compact Heat Exchangers with Multi-Region Louver Fins

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Air-side Heat Transfer Characteristics under Wet Conditions at Lower Ambient Pressure of Fin-and-tube Heat Exchanger

Detailed Heat Transfer Measurements of Curved Fin Channels

Research on the air-side thermal hydraulic performance of louvered fin and flat tube heat exchangers under low-pressure environment

Effect of Tip Clearance on the Heat Transfer and Pressure Drop Performance in the Micro-Reactor with Micro-Pin–fin Arrays at Low Reynolds Number

Experimental Study of the Lewis Factor of a Flatly and Straightly Finned Tube Heat Exchanger at the Air Side at a Low Atmospheric Pressure

Airside Performances of Finned Eight-Tube Heat Exchangers

Heat transfer of laminar oscillating flow in finned heat exchanger of pulse tube refrigerator

Effect of Environmental Pressure on Heat and Mass Transfer Characteristics for Fin-and-tube Heat Exchangers under Non-Unit Lewis Factor

Experimental Study on Heat Transfer Performance of the Multi-Region Louver Fins

A numerical and experimental study of chevron, corrugated-plate heat exchangers

Airside Heat Transfer and Pressure Loss Characteristics of Bare and Finned Tube Heat Exchangers Used for Aero Engine Cooling Considering Variable Air Properties

Numerical analysis of the flow and heat transfer characteristics of a staggered perforated louver-finned heat exchanger

Air-side flow and heat transfer characteristics research and empirical correlations of wavy fins in negative gauge pressure environment

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

Numerical studies on heat transfer and pressure drop characteristics of flat finned tube bundles with various fin materials

Heat-Transfer and Flow-Friction Characteristics of Some Compact Heat-Exchanger Surfaces: Part 1—Test System and Procedure

A Comprehensive Empirical Correlation for Finned Heat Exchangers with Parallel Plates Working in Oscillating Flow

Experimental and Numerical Investigations on Louvered Fin-and-Tube Heat Exchanger With Variable Geometrical Parameters

Performance Investigation of an Innovative Offset Strip Fin Arrays in Compact Heat Exchangers