Abstract:Air-side heat and mass transfer performance of plain fin-tube heat exchangers at different vacuum degree have been experimentally investigated. In this experiment, influence of air inlet humidity on air-side heat and mass transfer under vacuum environment is studied by controlling vacuum degree and air inlet humidity. Results show that: variation trend of air-side sensible heat transfer coefficient (ha), heat transfer j-factor (jh), mass transfer coefficient (hm) and mass transfer j-factor (jm) are not all time remain the same. Variation trend of ha, jh are the same with increase of vacuum degree when air inlet humidity changes, ha is gradually decreased and jh is gradually increased. Variation trend of hm is opposite with the increase of vacuum degree when the air inlet humidity changes. Under constant air inlet relative humidity conditions, hm is gradually increased. Under constant air inlet moisture content conditions, hm is gradually decreased. However, variation trend of jm is the same with increase of vacuum degree when air inlet humidity changes, both are increased. But slope of jm is greater under constant air inlet relative humidity conditions. Overall heat transfer performance is greatly affected by air inlet humidity changes. Under constant air inlet relative humidity conditions, when air inlet relative humidity increases from 50% to 70% and then to 90%, proportion of latent heat transfer increases from 30.98%∼53.99% to 36.53%∼56.95% and then increases to 44.19%∼64.04% with vacuum degree increases. As proportion of latent heat transfer increases, air-side total heat transfer performance is not obviously reduced. Under constant air inlet moisture content conditions, when air inlet moisture content increases from 15 to 20 g/kg, proportion of latent heat transfer is basically unchanged with increase of vacuum degree, at about 36% and 37%, respectively. So, total heat transfer performance on air side decreases obviously. In order to model air-side heat and mass transfer performance of the complex structure fin-tube heat exchangers, a simplified model is investigated under vacuum environment. Results show that influence of pressure changes on heat and mass transfer based on theory is basically consistent with the results of regression analysis based on experimental results. This study can provide guiding suggestions for the design of heat exchangers under vacuum environment.

Air-side Heat Transfer Characteristics under Wet Conditions at Lower Ambient Pressure of Fin-and-tube Heat Exchanger

Experimental Study of the Lewis Factor of a Flatly and Straightly Finned Tube Heat Exchanger at the Air Side at a Low Atmospheric Pressure

Effect of Environmental Pressure on Heat and Mass Transfer Characteristics for Fin-and-tube Heat Exchangers under Non-Unit Lewis Factor

Effect of ambient pressure on air side heat transfer and flow characteristics of plain finned tube heat exchanger

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

An Experimental Study on the Air Side Heat Transfer Performance of the Perforated Fin-Tube Heat Exchangers under the Frosting Conditions

Heat Transfer and Pressure Drop Correlations for Compact Heat Exchangers with Multi-Region Louver Fins

Research on the air-side thermal hydraulic performance of louvered fin and flat tube heat exchangers under low-pressure environment

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Air-side flow and heat transfer characteristics research and empirical correlations of wavy fins in negative gauge pressure environment

Airside Heat Transfer and Pressure Loss Characteristics of Bare and Finned Tube Heat Exchangers Used for Aero Engine Cooling Considering Variable Air Properties

Experimental Study of the Air Side Performance of Fin-and-Tube Heat Exchanger with Different Fin Material in Dehumidifying Conditions

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Heat transfer of laminar oscillating flow in finned heat exchanger of pulse tube refrigerator

Effect Of Corrugation Angle Of Fin On Performance Of A Wavy Finned Tube Heat Exchanger Under Constant Fan Power Condition

A New General Correlation for Frictional Pressure Drop During Condensation Inside Horizontal Micro-Fin Tubes

Effect of vacuum environment on air side heat and mass transfer characters of plain fin-tube heat exchangers

Numerical Investigation Of Effect Of Tube Shape On Air-Side Heat Transfer And Pressure Drop Characteristics Of A Finned Tube Heat Exchanger

Thermal-hydraulic performance evaluation of airside of wavy fin compact heat exchangers under wet conditions