Abstract:Packed bed reactor (PBR) is the commonly used configuration in plasma catalysis, and its plasma characteristics have been extensively investigated. The filled catalysts in PBR make it challenging to carry out in-situ measurements of electric fields, and limited experimental data have been obtained. We investigated the surface streamer propagation and electric field distribution in a simplified PBR through simulations and experiments. The simplified PBR in the experiments is comprised of a blade-plate electrode structure filled with an Al2O3 column (epsilon(r) = 9) in the discharge gap. An ICCD camera and an electric field diagnosis method called EFISH (electric field induced second harmonic generation) were employed, and a two-dimensional fluid model was established for the simulation. Four discharge types in the PBR were identified based on ICCD images and simulation results, including polar discharge at the contact areas, surface streamer along the dielectric column, expansion of surface discharge along the dielectric column, and surface ionization waves along the dielectric plate. Surface streamers with opposite propagation directions were found in the model, namely the forward streamer during the pulse rising time and the reverse streamer during the pulse falling time. Notably, the reverse streamer exhibits a significantly lower velocity compared to the forward streamer. Both experimental measurements and simulation were conducted to investigate the spatiotemporal electric field near the surface of the packing material. The results of both E (exp) and E (sim) showed peaks with opposite polarities, and exhibited similar trends. In the simulation, the forward streamer head showed a higher electric field compared to the reverse streamer head. Moreover, during the rest pulse time, the surface electric field was more intense at the contact areas than in other regions. The findings of this work provide valuable insights into the discharge mechanism and electric field on the catalytic material surface within the PBR.

Plasma Generation Method Based on DC Corona Discharge and Back Corona Discharge on Catalyst

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Non-thermal Plasma Generation by Using Back Corona Discharge on Catalyst

From Chemical Kinetics to Streamer Corona Reactor and Voltage Pulse Generator

Comparison of Two-Type Corona Plasma Energization Techniques: Ultra-Short and DC/AC Power Sources

AC/DC Power Modulation for Corona Plasma Generation

A High-Voltage Pulse Generator for Corona Plasma Generation

Pulsed Corona Generation Using a Diode-Based Pulsed Power Generator

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

Streamer Corona Plasmas and the Chemical Effects on NO Removal

Streamer Corona Plasma for Fuel Gas Cleaning: Comparison of Energization Techniques

Streamer Corona Plasmas and NO Removal

An Industrial Streamer Corona Plasma System for Gas Cleaning

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

Static Electric Field Intensity Calculation of Two Kinds of Electrode Structure Plasma Generator

Development of back corona discharge in a wire-cylinder electrostatic precipitator at high temperatures

Experimental and Numerical Investigation of Surface Streamers in a Nanosecond Pulsed Packed Bed Reactor

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Enhancement of Active Species Formation by Catalysis in the Bipolar Pulsed Discharge Plasma System

Dielectric Barrier Discharge Plasma-Assisted Catalytic CO2 Hydrogenation: Synergy of Catalyst and Plasma

A Review of Recent Advances of Dielectric Barrier Discharge Plasma in Catalysis