Abstract:A novel plasma-driven catalysis (PDC) reactor with special structure was proposed to remove vehicle exhaust gas. The PDC reactor which consisted of three quartz tubes and two copper electrodes was a coaxial dielectric barrier discharge (DBD) reactor. The inner and outer electrodes firmly surrounded the outer surface of the corresponding dielectric barrier layer in a spiral way, respectively. Nano-titanium dioxide (TiO2) film prepared by radiofrequency (RF) magnetron sputtering was coated on the outer wall of the middle quartz tube, separating the catalyst from the high voltage electrode. The spiral electrodes were designed to avoid overheating of microdischarges inside the PDC reactor. Continuous operation tests indicated that stable performance without deterioration of catalytic activity could last for more than 25 h. To verify the effectiveness of the PDC reactor, a non-thermal plasma(NTP) reactor was employed, which has the same structure as the PDC reactor but without the catalyst. The real vehicle exhaust gas was introduced into the PDC reactor and NTP reactor, respectively. After the treatment, compared with the result from NTP, the concentration of HC in the vehicle exhaust gas treated by PDC reactor reduced far more obviously while that of NO decreased only a little. Moreover, this result was explained through optical emission spectrum. The O emission lines can be observed between 870 nm and 960 nm for wavelength in PDC reactor. Together with previous studies, it could be hypothesized that O derived from catalytically O-3 destruction by catalyst might make a significant contribution to the much higher HC removal efficiency by PDC reactor. A series of complex chemical reactions caused by the multi-components mixture in real vehicle exhaust reduced NO removal efficiency. A controllable system with a real-time feedback module for the PDC reactor was proposed to further improve the ability of removing real vehicle exhaust gas.

Non-thermal Plasma Generation by Using Back Corona Discharge on Catalyst

Plasma Generation Method Based on DC Corona Discharge and Back Corona Discharge on Catalyst

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Toluene Decomposition by a Two-stage Hybrid Plasma Catalyst System in Dry Air

From Chemical Kinetics to Streamer Corona Reactor and Voltage Pulse Generator

Corona-induced Non-Thermal Plasma for Gas Cleaning

Plasma Induced Toluene Decomposition on Alumina-Supported Mn-Based Composite Oxides Catalysts

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

A High-Voltage Pulse Generator for Corona Plasma Generation

The Mechanism of Non-thermal Plasma Catalysis on Volatile Organic Compounds Removal

Decomposition of Toluene Using Nanosecond- Pulsed-Discharge Plasma Assisted with Catalysts

Vehicle Exhaust Gas Clearance By Low Temperature Plasma-Driven Nano-Titanium Dioxide Film Prepared By Radiofrequency Magnetron Sputtering

A Review of Recent Advances of Dielectric Barrier Discharge Plasma in Catalysis

Nonthermal plasma catalysis using ferrites as an efficient catalyst for toluene degradation

By-product reduction for the non-thermal plasma removal of toluene using an α-MnO 2 /Cordierite honeycomb monolithic catalyst in a honeycomb structure

Plasma Application for More Environmentally Friendly Catalyst Preparation

Environmental plasma-catalysis for the energy-efficient treatment of volatile organic compounds

Refluxing-coprecipitation to synthesize Fex−Mny/γ-Al2O3 catalyst for toluene removal in a nonthermal plasma-catalysis reactor

Catalyzing Industrial Wastes Through Discharge Plasma for Diesel Exhaust Cleaning: A Case Study with Cascaded Corona Reactors

Catalytic non-thermal plasma reactor operating at low applied voltage for the removal of toluene in air