Density measurements of endothermic hydrocarbon fuel using random temperature signal cross-correlation

Chen GENG,Yajun GUO,Song FENG,Qincheng BI
DOI: https://doi.org/10.11949/j.issn.0438?1157.20180970
2019-01-01
Abstract:To measure the density of a new endothermic hydrocarbon fuel (EHF) at supercritical pressures, a new densimeter, which is based on the mass conservation equation and cross-correlation method, was designed and constructed. Two K-type thermocouples with the same thermoelectric characteristics were installed in the upstream and downstream of the test tube with distance of 148 mm as the cross-correlation sensor. The delay time was found using the cross-correlation between upstream and downstream signal which were measured by the thermocouples. High sampling rate and correlation coefficient were used to ensure the accuracy and similarity of the signals. So the mean flow velocity could be calculated by the delay time and distance. With the flow velocity and mass flow rate known, the density could be determined based on the mass conservation equation. The n-dodecane and the binary mixture of n-octane and n-heptane with mass ratio of 1∶1 were tested for the system calibration. According to error analysis, the maximum relative deviations were below ± 1.2%, and the absolute average relative deviations were within 0.6%. On the basis of calibration experiments, this measurement covers the temperature range of 302.0—529.6 K under pressures from 3.0 MPa to 5.0 MPa. The application of this method provides a new thinking of the density on-line measurement of endothermic hydrocarbon fuel under supercritical pressures.
What problem does this paper attempt to address?