Abstract:It has been widely considered that the global warming was induced by the increasing atmospheric concentrations of carbon dioxide, which has a significant impact on the sustainable development of the human society. Injecting carbon dioxide into depleted oil / gas reservoir has been developed to reduce carbon dioxide emission by the sequestration of CO2 underground, which is also considered as one promising approach to enhance oil recovery simultaneously. The evaluating of CO2 sequestration in oil reservoir needs highly accurate experimental data and models about the thermodynamic characters of CO2 + oil mixture. Density is one of key physical characters for simulating the diffusion and migration of carbon dioxide under the oil / gas reservoir. Research on volumetric behaviour is helpful to understand the expansion of the liquid phases in CO2 + oil mixture.In this paper, decane is investigated instead of petroleum because of the similar thermal physical property. The measurements have been performed at pressures from 12 MPa to 18 MPa and temperatures from 313.15 K to 343.15 K at four compositions x(1) (x(1) is the mole fraction of carbon dioxide) = 0.8690, 0.9135, 0.9430 and 0.9818 by a magnetic suspension balance (MSB). The accuracy of the experimental quantities presented in this work are T / K = +/- 0.01, m / g = +/- 10(-5) respectively. One circulation pump (AKICO, Japan) is equipped to accelerate the dissolution of CO2 in decane. Some conclusions can be obtained from the experiment as follow: (1) the dissolution of CO2 increases the density of decane, the density of CO2 + decane solution increases with increasing pressure and decreases with increasing temperature. (2) the slope of density with respect to pressure increases with increasing CO2 mole fractions while the slope with respect to temperature decreases with increasing CO2 mole fractions. (3) the crossover phenomenon appears at different compositions and the crossover pressure increases with temperature. (4) the excess molar volumes of this binary mixture are negative and show negative increasing with temperature for the data reported in this work. The GERG - 2008 model is used to predict density of CO2 + decane solution, which takes temperature, pressure, and CO2 concentration into account. An empirical equation is also used to predict the density of this binary mixture. The predictions show that the empirical equation is in good agreement with the experimental data over the experimental range. The measurement and the model used in this work supplies the basic experimental data and theoretical analysis to CO2 sequestration and enhance oil recovery. (C) 2013 The Authors. Published by Elsevier Ltd.

Density Measurements on Binary Mixtures (nitrogen + Carbon Dioxide and Argon + Carbon Dioxide) at Temperatures from (298.15 to 423.15) K with Pressures from (11 to 31) MPa Using a Single-Sinker Densimeter

Accurate Density Measurements on Ternary Mixtures (carbon Dioxide + Nitrogen + Argon) at Temperatures from (323.15 to 423.15) K with Pressures from (3 to 31) MPa Using a Single-Sinker Densimeter

Accurate Density Measurements on a Binary Mixture (carbon Dioxide + Methane) at the Vicinity of the Critical Point in the Supercritical State by a Single-Sinker Densimeter

Density Characteristics of a Multicomponent CO2/N2/CH4 Ternary Mixture at Temperature of 293.15–353.15 K and Pressure of 0.5–18 MPa

Densities of CO2/N2/O2 ternary mixtures at temperatures from (300.15 to 353.15) K and pressures from (5 to 18) MPa

Density Characteristics of CO2–CH4 Binary Mixtures at Temperatures from (300 to 308.15) K and Pressures from (2 to 18) MPa

Accurate experimental ($p$, $ρ$, $T$) data of the ($CO_{2}$ + $O_{2}$) binary system for the development of models for CCS processes

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa

Measuring and Modeling the Density of Some Typical Binary Mixtures in the Conditions of 280-423.15 K and 0.1-9 MPa

Density Characteristics of the CO2–CH4 Binary System: Experimental Data at 313–353 K and 3–18 MPa and Modeling from the PC-SAFT EoS

Densities and Volumetric Characteristics of Binary System of CO2 + Decane from (303.15 to 353.15) K and Pressures Up to 19 MPa

Density Data of Two (H2 + CO2) Mixtures and a (H2 + CO2 + CH4) Mixture by a Modified Burnett Method at Temperature 673 K and Pressures Up to 25 MPa

Densities Of The Binary System Of Carbon Dioxide And Dodecane From (313 To 353) K And Pressures Up To 18 Mpa

Densities And Excess Volumes Of Co2 + Decane Solution From 12 To 18 Mpa And 313.15 To 343.15 K

Liquid Densities of N-Octane, Ethylcyclohexane and Their Binary Mixtures {(x) N-Octane) + (1 − X) Ethylcyclohexane} at Temperatures from (283 to 363) K and Pressures Up to 60 MPa

Raman spectroscopic densimeter for pure CO2 and CO2-H2O-NaCl fluid systems over a wide P-T range up to 360 °C and 50 MPa

Density and Volumetric Properties of Binary Mixtures of CO2 + Hexadecane from (303.2 to 473.2) K and Pressures Up to 50.0 MPa

PρT Measurements and Modelling of (N-Decane + M-Xylene) Mixtures from 293.15 K to 363.15 K at Pressures Up to 60 MPa

The Four-Sinker Densimeter: A New Instrument for the Combined Investigation of Accurate Densities and Sorption Phenomena of Pure Gases and Gas Mixtures

Density Measurements of the H-2-CO2-CH4-CO-H2O System by the Isochoric Method at 722-930 K and 15.4-30.3 MPa

Accurate experimental ($p$, $ρ$, $T$) data of natural gas mixtures for the assessment of reference equations of state when dealing with hydrogen-enriched natural gas