Abstract:The working range of hydrocarbon fuel has gradually expanded to high pressure/high temperature conditions above the critical point with the proposal of "dual carbon" strategy. The calculation accuracy of fuel thermophysical properties in the power systems has become a major difficulty. In this study, the density, internal energy, enthalpy, entropy, thermal conductivity and viscosity of n -dodecane molecular system were calculated using the SKS-UA force field in the isothermal-isobaric (NPT) ensemble via molecular dynamics (MD) simulations in the range of temperatures from 298 K to 2000 K and pressures from 1.2773 atm to 3000 atm. Three modification methods in terms of stability modification, kernel density estimation (KDE) modification and zero potential energy surface modification were proposed to improve the calculation accuracy. Average absolute relative deviation (AARD) and standard error (SE) were employed to perform error and uncertainty analysis on existing and non-existent thermophysical properties data of n -dodecane, respectively. The results indicated that the modified results for the six thermophysical properties are better than the original ones. The modified density, internal energy, enthalpy, entropy, and thermal conductivity were in good agreement with the experimental values, while the viscosity is underestimated at low temperature. The change in thermophysical properties was enormous near the critical point. Among the conditioned factors, pressure had a greater impact on density and thermal conductivity, while internal energy, enthalpy and entropy were more sensitive to temperature. Viscosity changed significantly when the temperatures were below the critical point. This modification method offers high-precision calculation results, inspiring the prediction of thermophysical properties over a wide temperature and pressure range.

Distributed Flow Calorimetry With Wide Temperature and Pressure Range Based on Scanning Radiation Thermometry

A fluid temperature interpolation method for wide temperature range distributed flow calorimeter

PHASE DETECTION AIDED THERMOMETRY AND ITS APPLICATION TO NATURAL CONVECTIVE SUBCOOLED FLOW BOILING IN A NARROW GAP

Flow Dynamics in Transient Heat Transfer of N-Decane at Supercritical Pressure

Design of A Flow Calorimeter for Hydrocarbon Fuel at Temperatures from (330 to 900) K and Pressures Up to 6.0 Mpa

Experimental Investigation on Flow Boiling Heat Transfer Characteristics of Endothermic Hydrocarbon Fuel and Its Visualization at High-Temperature Conditions

Multidimensional high-temperature field measurement method for flame based on near infrared radiation spectrum of water vapor

Density measurements of endothermic hydrocarbon fuel using random temperature signal cross-correlation

A New Flow Calorimeter For The Determination Of The Isobaric Heat-Capacity Of Vapors

Experimental study on the thermodynamic characteristics of the high temperature hydrocarbon fuel in the cooling channel of the hypersonic vehicle

On-line Measurement of Isobaric Specific Heat Capacity for Endothermic Hydrocarbon Fuel at High Temperature

Thermophysical properties of n -dodecane over a wide temperature and pressure range via molecular dynamics simulations with modification methods

Viscosity Measurement of Endothermic Fuels at Temperatures from 303 K to 673 K and Pressures Up to 5.00 MPa

Feasibility Analysis on Radiant Transient Heat Flux Meter Calibration System

Dynamic compensation by coupled triple-thermocouples for temperature measurement error of high-temperature gas flow

Numerical Investigation on the Heat Transfer of <i>n</i>-Decane in a Horizontal Channel with Axially Nonuniform Heat Flux under Supercritical Pressure

Estimation of Thermophysical Properties of a Hydrocarbon Fuel at Supercritical Pressure

Measurement of Gas-Liquid Flows with the Combination of Thermal Sensors and Conductance Sensor

Parameter-Free Data Reduction for Short-Time Hypersonic Heat Flux Measurements

A hybrid CFD-RMD multiscale coupling framework for interfacial heat and mass simulation under hyperthermal ablative conditions

High-Speed and High-Temperature Calorimetric Solid-State Thermal Mass Flow Sensor for Aerospace Application: A Sensitivity Analysis