Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Studies on Gas-Liquid Mass Transfer Characteristics of Horizontal Vessel

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

[Gas-Liquid Mass Transfer in Three-Phase Inverse Turbulent Bed Reactor].

Experimental study and CFD simulation of mass transfercharacteristics of a gas-induced pulsating flow bubblecolumn

Effects of Internal Structures on Mass Transfer Performance of Jet Bubbling Reactor

Mass Transfer Coefficient for Two-Phase Countercurrent Flow in a Packed Column with a Novel Internal

Gas-Liquid Dispersion and Mixing Characteristics and Heat Transfer in A Stirred Vessel

Experimental study on gas–liquid interfacial area and mass transfer coefficient in three-phase circulating fluidized beds

Local Overall Gas–liquid Mass Transfer Coefficient in a Gas–liquid–solid Reversed Flow Jet Loop Reactor

Gas-Liquid Interfacial Area and Mass Transfer Coefficient in a Three-phase Circulating Fluidized Bed

Local gas-liquid dispersion properties in a dual-impeller stirred vessel

LIQUID CIRCULATION RATE AND VOLUMETRIC MASS TRANSFER COEFFICIENT IN MULTI-TUBE AIRLIFT LOOP REACTOR

The study on mass transfer characteristics of the intensified gas-liquid jet stirred reactor

Liquid Circulation Velocity and Local Gas Holdup in Air-lift Loop Reactor

Gas–liquid mass transfer behavior in three-phase CFB reactors

Influence of Sparger Type on Mass Transfer in a Pilot-Scale Internal Loop Airlift Reactor

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

Experimental investigation, modelling, and order of magnitude analysis of oxygen mass transfer in pulsed plate column with α‐Fe2O3 nanofluid