Abstract:Mass transfer performance is markedly improved in microchannels compared with traditional gas-liquid chemical devices. The residence time is a crucial parameter for determining the mass transfer performance. However, investigation of the residence time in gas-liquid absorption systems remains insufficient, especially in viscous gas-liquid systems with obvious flow non-uniformity between the two phases. Herein, the microscale gas-liquid flow and mass transfer performance in viscous liquids (9.0-55.4 mPa center dot s) based on the true residence time are investigated. Owing to the broad operating conditions of the gas-liquid flow ratio (0.2-6.7), both Taylor flow and bubbly flow patterns were observed. The results show that the bubble velocity gradually decreases to the minimum value with increasing flow distance in the Taylor flow pattern owing to gas absorption. Subsequently, bubble velocity gradually increases under the bubbly flow pattern, and the dominant factor of bubble velocity is pointed out. The true bubble residence time initially increases and then gradually decreases compared to the superficial time as the gas holdup decreases, based on the superficial velocity using the initial flow rates. The transition point occurs at a gas holdup of 0.2. In addition, the turning point of the different rules of the pressure drop occurs at a gas holdup of 0.5. Finally, a new dimensionless equation was proposed to predict the mass transfer coefficient and reveal the equation differences between low-and high-viscosity liquids. This work enriches the understanding of microflow characteristics and mass transfer performance in viscous solutions and provides a reliable guide for microreactor design.

The study on mass transfer characteristics of the intensified gas-liquid jet stirred reactor

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

Effects of Internal Structures on Mass Transfer Performance of Jet Bubbling Reactor

[Gas-Liquid Mass Transfer in Three-Phase Inverse Turbulent Bed Reactor].

Intensification on Mass Transfer Between Gas and Liquid in Fine Bubble Jet Reactor

Experimental study on gas–liquid interfacial area and mass transfer coefficient in three-phase circulating fluidized beds

Experimental and numerical investigations of motion and mass transfer of single bubbles in a turbulent flow chamber

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Experimental study and CFD simulation of mass transfercharacteristics of a gas-induced pulsating flow bubblecolumn

Gas-Liquid Interfacial Area and Mass Transfer Coefficient in a Three-phase Circulating Fluidized Bed

Mass transfer mechanism and relationship of gas–liquid annular flow in a microfluidic cross-junction device

Hydrodynamics and Mass Transfer Performance of Gas–liquid Microflow in Viscous Liquids

Bubble Diameter, Mass Transfer, and Bioreaction of Dynamic Membrane-Stirred Reactors

Flow regime transition and bubble behavior in gas-liquid two-phase impinging jet reactor

Effect of Mixing on Mass Transfer Characterization in Continuous Slugs and Dispersed Droplets in Biphasic Slug Flow Microreactors

Microinterface Intensification in Hydrogenation and Air Oxidation Processes

Modeling investigation of mass transfer of gas-liquid-liquid dispersion systems

Ultrasound-assisted gas–liquid mass transfer process in microreactors: The influence of surfactant, channel size and ultrasound frequency