Abstract:Lateral gas mixing was experimentally studied in the freeboard zones of 3 cold CFB test rigs with different sections of 0.19ml ID, 0.3m 0.3m, 0.25m and 0.5m respectively and with the same net furnace height of 4m. Sands were used as the bed material and CO(2) was used as the tracer gas. The influences of operational condition such as superficial velocity, suspension solid density, shape and size of the riser on gas mixing were studied. It was found that with particles. present in the bed the lateral gas dispersion will decrease and the highest lateral dispersion exists in a particle-free bed. The addition of solid particles will first weaken the dispersion and then as the particle load is high than a critical value, the further addition of particles may enhance gas dispersion. In this study the solid density at the transition point is about 8-10kg/m3, varying with the,suspension velocity. It is believed that such a transition is mainly caused by the transition of flow pattern in the riser. The superficial velocity has only minor influence on the gas dispersion in the range of,which, is used in an industrial CFB boiler. The effect of riser diameter on the lateral mixing coefficient is stronger than that of solid suspension density and superficial velocity. In this study and previous studies Dr increases liner with the riser's equivalent diameter.

Gas–liquid mass transfer behavior in three-phase CFB reactors

Gas-Liquid Interfacial Area and Mass Transfer Coefficient in a Three-phase Circulating Fluidized Bed

Experimental study on gas–liquid interfacial area and mass transfer coefficient in three-phase circulating fluidized beds

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

[Gas-Liquid Mass Transfer in Three-Phase Inverse Turbulent Bed Reactor].

Gas-liquid mass transfer in a gas–liquid-solid three-phase moving bed

Gas-Liquid Mass Transfer in A Slurry Bubble Column Reactor under High Temperature and High Pressure

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Oxygen Mass Transfer in the Liquid Phase of a Three-phase Continuous Loop Reactor

Oxygen mass transfer coefficient in bubble column slurry reactor with ultrafine suspended particles and neural network prediction

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

Experimental study on bubble behavior in gas–liquid–solid three-phase circulating fluidized beds

Oxygen Mass Transfer Behaviors of the Aerating Process in Inner-loop Aerobic Biological Fluidized Bed Reactor

Lateral Gas Mixing In The Freeboard Zone Of A Cfb Boiler

Gas Mixing In The Cocurrent Downflow Circulating Fluidized-Bed

Experimental study and CFD simulation of mass transfercharacteristics of a gas-induced pulsating flow bubblecolumn

Local Heat and Mass Transfer for Gas-Solid Two Phase Flow in CFB

Liquid dispersion in gas-liquid-solid circulating fluidized beds

Volumetric Mass Transfer Coefficient of Oxygen in an Internal Loop Airlift Reactor with A Convergence-Divergence Draft Tube

Gas Holdup, Bubble Behavior and Mass Transfer in A 5 M High Internal-Loop Airlift Reactor with Non-Newtonian Fluid

Phase Holdup and Liquid Dispersion in Gas-Liquid-Solid Circulating Fluidized Beds