Abstract:The gas–solid flow characteristics greatly influence the heat transfer, combustion and pollutant formation processes in a circulating fluidized bed (CFB) boiler. The effects of particle size on the gas–solid flow characteristics, including flow structure, axial pressure and bed density profiles were studied in a two-dimensional CFB cold apparatus under low solid circulation rates ( G s 's). At the same time, an optical fiber probe was used to assess the particle size effect on the formation of particle clusters and their properties under different operating conditions. Results revealed that when the averaged size of bed materials decreased from ∼200 μm to ∼100 μm, at the same operating condition, the bottom dense bed became remarkably higher, and the upper dilute zone had stronger pressure fluctuation, more even axial and horizontal particle distributions, and higher solid density. G s was more sensitive to the variation of the superficial gas velocity than the bed inventory. In addition, the standard deviation and power spectrum density of instantaneous pressure decreased in the dense bed and increased in the dilute zone. The particle velocity was slightly lower in the lower section of the riser but noticeably greater in the upper riser section. In addition, the clusters formed more frequently and lasted significantly longer. The study showed that flow characteristics in the bed qualitatively changed from that of Type B particles to that Type A particles in the Geldart's classification, even at a small G s , and previous studies with Type B particles could very likely not apply in the CFB boilers operating with fine bed materials.

Lateral Gas Mixing In The Freeboard Zone Of A Cfb Boiler

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Lateral Solids Mixing In The Dense Zone Of A Circulating Fluidized Bed

Gas Mixing In The Cocurrent Downflow Circulating Fluidized-Bed

Gas concentration profiles in the furnace of large CFB boilers with water-cooled square separator

Experimental Study on Gas-Solid Flow Charcteristics in a CFB Riser of 54M in Height

Radial Gas Mixing in the Dilute Region in a CFB Riser

MP-PIC Simulation on Solid Dispersion in a 350 MW CFB Boiler

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

The Mechanism of Lateral Solid Transfer in a CFB Riser with Pant-Leg Structure

Effect of Superficial Gas Velocity on Solid Behaviors in a Full-Loop CFB

Gas–liquid mass transfer behavior in three-phase CFB reactors

Study on Gas-solids Flow Properties in the 38m/54m Riser of Circulating Fluidized Bed

A Study of the Transverse Dispersion of Solid Particles in the Dense-phase Zone of a Circulating Fluidized Bed Boiler

Effect of bed material size on gas-solid flow characteristics in a CFB at low solid recirculation rates

Gas Concentration Profiles in the Furnace of CFB Boilers

Modeling Study on Non‐Uniform Lateral Distribution in Large‐Scale Circulating Fluidized Bed Boilers

Effects of Riser Height and Total Solids Inventory on the Gas–solids in an Ultra-Tall CFB Riser

Hydrodynamics and Lateral Gas Dispersion in A High-Density Circulating Fluidized Bed Reactor with Bluff Internals

Experimental study on secondary air mixing along the bed height in a CFB with a multi-tracer-gas method

EFFECT OF INTERNALS ON GAS DISPERSION IN HIGH DENSITY RISER