Abstract:Dual circulating fluidized bed (DCFB) has emerged as an efficient reactor for biomass gasification due to its unique feature of high gas-solid contact efficiency and separated reactions in two reactors, yet the understanding of complex in-furnace phenomena is still lacking. In this study, biomass gasification in an industrial-scale DCFB system was numerically studied using a multiphase particle-in-cell (MP-PIC) method featuring thermochemical sub-models (e.g., heat transfer, heterogeneous reactions, and homogeneous reactions) under the Eulerian-Lagrangian framework. After model validation, the hydrodynamics and thermochemical characteristics (i.e., pressure, temperature, and species) in the DCFB are comprehensively investigated. The results show that size-/density-induced segregation makes solid fuels concentrate on the bed surface. Interphase momentum exchange leads to the continuous decrease of the gas pressure axially. In the gasifier and combustor, the lower heating value (LHV) of the gas products is 5.56 MJ/Nm3 and 0.2 MJ/Nm3 and the combustible gas concentration (CGC) is 65.5% and 1.86%, respectively. The temperature in the combustor is about 100 K higher than that in the gasifier. A higher solid concentration results in a smaller value of particle heat transfer coefficient (HTC). The HTCs range from 50 to 150 W/(m2 K) for a solid concentration larger than 0.3 in the combustor while the HTCs range from 100 to 200 W/(m2 K) in the gasifier. The Reynolds number of biomass particles is two orders of magnitude larger than that of the sand particle. The numerical results shed light on the reactor design and process optimization of biomass gasification in DCFBs.

MP-PIC Simulation on Solid Dispersion in a 350 MW CFB Boiler

12th International Conference on Fluidized Bed Technology MODELING STUDY ON NON-UNIFORM DISTRIBUTION IN THE LATERAL DIRECTION IN LARGE SCALE CFB BOILERS

Investigation on Solid Dispersion in a CFB Dense Region with Bluetooth Tracking Method and MP-PIC Simulation

A Study of the Transverse Dispersion of Solid Particles in the Dense-phase Zone of a Circulating Fluidized Bed Boiler

Three-dimensional Full-Loop Numerical Simulation of Co-Combustion of Coal and Refuse Derived Fuel in a Pilot-Scale Circulating Fluidized Bed Boiler

Lateral Gas Mixing In The Freeboard Zone Of A Cfb Boiler

Mass Balance Performance Of A 300mw Cfb Boiler Burning Blend Fuel With Different Mixing Ratio

Impact of Particle Size Polydispersity on Chemical Looping Combustion of Biomass under a Continuous Injection Mode

Discrete Element Study of Solid Circulating and Resident Behaviors in an Internally Circulating Fluidized Bed

Particle residence time distribution and axial dispersion coefficient in a pressurized circulating fluidized bed by using multiphase particle-in-cell simulation

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach

Particle Population Balance Model for a Circulating Fluidized Bed Boiler

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

Study of biomass gasification in an industrial-scale dual circulating fluidized bed (DCFB) using the Eulerian-Lagrangian method

Modeling Study on Non‐Uniform Lateral Distribution in Large‐Scale Circulating Fluidized Bed Boilers

Lateral dispersion coefficient of large solid particles in CFB dense zone using CPFD method

Numerical Modelling of the Co-Firing of Pulverised Coal and Straw in A 300 Mwe Tangentially Fired Boiler

Numerical Simulation of Gas-solid Hydrodynamics in a 600 MW Supercritical Circulating Fluidized Bed Boiler Furnace

CPFD numerical study on tri-combustion characteristics of coal, biomass and oil sludge in a circulating fluidized bed boiler

Application of CPFD Approach on Gas-solid Flow and Combustion in Industrial CFB Boilers

Numerical Simulation of Secondary Air Penetration Depth in a 300 MW Single-furnace Circulating Fluidized Bed Boiler