Abstract:A series of MnCo/Cu-ZSM-5 (MnCo/Cu-Z) catalysts with different Mn/Co ratios for the selective catalytic reduction (SCR) of NO with NH3 were prepared by the combination of ion exchange and impregnation. The physicochemical properties of the catalysts were investigated by N2 adsorption/desorption, X-ray diffraction (XRD), temperature-programmed reduction with hydrogen (H2-TPR), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption of NOx (NOx-TPD) and NH3 (NH3-TPD), and the diffuse reflectance infrared Fourier transform (DRIFT) technique was employed for the detection of intermediate species and the study of the mechanism. The introduction of Mn and Co boosts the catalytic activity of the Cu-Z catalyst at a temperature below 200 °C, and the optimum activity was obtained over the Mn1Co2/Cu-Z catalyst. The enrichment of the high-valent metal ion on the catalyst surface and the improvement in the reducibility of metal oxide are responsible for the elevation in the catalytic activity of MnCo/Cu-Z. The bridged and bidentate modes are the prevailing nitrate species on the Cu-Z and MnCo/Z catalysts, respectively, and both of them were detected over the MnCo/Cu-Z catalyst. Furthermore, the DRIFT spectroscopy (DRIFTS) results indicate that, at 150 °C, the bridged nitrate can react with the adsorbed ammonia species, but the bidentate nitrate fails to do. The SCR reaction over the Cu-Z catalyst follows the Eley–Rideal and Langmuir–Hinshelwood mechanisms simultaneously at 150 °C, whereas an overwhelming dominance of the Eley–Rideal mechanism is identified for the MnCo/Z catalyst. As to the SCR mechanism on the MnCo/Cu-Z catalyst, it combines the features of Cu/Z and Mn1Co2/Z.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c01172?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c01172</a>.Physical properties of catalysts; peak positions and assignments in the DRIFT Spectra; effects of H2O on NOx conversion; effects of H2O on the stability of catalysts; EDS element mapping of catalysts; and relative amount of surface acid sites (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c01172/suppl_file/cs1c01172_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Study on the selective catalytic reduction of NO by C3 H6 with metal organic material MOF-5

Investigation on the redox/acidic features of bimetallic MOF-derived CeMOx catalysts for low-temperature NH3-SCR of NOx

Catalytic performance of MnO 2-CeO 2/Ti 0.25Zr 0.25Al 0.5O 1.75 monolith catalyst for low temperature selective catalytic reduction of NO with NH 3

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

Activation of Fast Selective Catalytic Reduction of NO by NH3 at Low Temperature over TiO2 Modified CuOX-CeOX Composites

Selective Catalytic Reduction of NO over Mo/ZSM-5 Catalyst

A novel Cu-Mo/ZSM-5 catalyst for NOx catalytic reduction with ammonia

Cu-ZSM-5 Catalyst Impregnated with Mn–Co Oxide for the Selected Catalytic Reduction of NO: Physicochemical Property–Catalytic Activity Relationship and In Situ DRIFTS Study for the Reaction Mechanism

Bifunctional Catalyst of CuMn-HZSM-5 for Selective Catalytic Reduction of NO and CO Oxidation under Oxygen Atmosphere

Molybdenum loaded on HZSM-5: A catalyst for selective catalytic reduction of nitrogen oxides

The selective catalytic reduction of NO over Ce0.3TiOx-supported metal oxide catalysts

Copper-based catalysts supported on novel Metal-Organic Framework MIL-125(Ti) for selective catalytic reduction of NO with CO

Influence of different preparation methods on the activity of Ce and Mo co-doped ZSM-5 catalysts for the selective catalytic reduction of NOx by NH3

Activity Test and Mechanism Study of 3DOM Ce 0.8 M 0.1 Zr 0.1 O 2 (M=Cr, Sn, Fe, Co, Ni, Mn, Cu) Catalyst in the Selective Catalytic Reduction of NO by CO**

Selective catalytic reduction of NO with NH3 over CuOX-carbonaceous materials

A study on chemisorbed oxygen and reaction process of Fe–CuO x /ZSM-5 via ultrasonic impregnation method for low-temperature NH 3 -SCR

Study on Catalytic Reduction of NO on CuO/TiZrO4 in the Presence of Excess Oxygen

Activity and Characterization of Ce–Mo–Ti Mixed Oxide Catalysts Prepared by a Homogeneous Precipitation Method for Selective Catalytic Reduction of NO with NH3

Selective catalytic reduction of NO with C3H6 over CuCl/ZSM-5 zeolites prepared by disperse method

In Situ Supported Mnox-Ceox On Carbon Nanotubes For The Low-Temperature Selective Catalytic Reduction Of No With Nh3

On the performance of Fe-Cu-ZSM-5 catalyst for the selective catalytic reduction of NO with NH3: the influence of preparation method