Abstract:A series of MnCo/Cu-ZSM-5 (MnCo/Cu-Z) catalysts with different Mn/Co ratios for the selective catalytic reduction (SCR) of NO with NH3 were prepared by the combination of ion exchange and impregnation. The physicochemical properties of the catalysts were investigated by N2 adsorption/desorption, X-ray diffraction (XRD), temperature-programmed reduction with hydrogen (H2-TPR), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption of NOx (NOx-TPD) and NH3 (NH3-TPD), and the diffuse reflectance infrared Fourier transform (DRIFT) technique was employed for the detection of intermediate species and the study of the mechanism. The introduction of Mn and Co boosts the catalytic activity of the Cu-Z catalyst at a temperature below 200 °C, and the optimum activity was obtained over the Mn1Co2/Cu-Z catalyst. The enrichment of the high-valent metal ion on the catalyst surface and the improvement in the reducibility of metal oxide are responsible for the elevation in the catalytic activity of MnCo/Cu-Z. The bridged and bidentate modes are the prevailing nitrate species on the Cu-Z and MnCo/Z catalysts, respectively, and both of them were detected over the MnCo/Cu-Z catalyst. Furthermore, the DRIFT spectroscopy (DRIFTS) results indicate that, at 150 °C, the bridged nitrate can react with the adsorbed ammonia species, but the bidentate nitrate fails to do. The SCR reaction over the Cu-Z catalyst follows the Eley–Rideal and Langmuir–Hinshelwood mechanisms simultaneously at 150 °C, whereas an overwhelming dominance of the Eley–Rideal mechanism is identified for the MnCo/Z catalyst. As to the SCR mechanism on the MnCo/Cu-Z catalyst, it combines the features of Cu/Z and Mn1Co2/Z.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c01172?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c01172</a>.Physical properties of catalysts; peak positions and assignments in the DRIFT Spectra; effects of H2O on NOx conversion; effects of H2O on the stability of catalysts; EDS element mapping of catalysts; and relative amount of surface acid sites (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c01172/suppl_file/cs1c01172_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Activity Test and Mechanism Study of 3DOM Ce 0.8 M 0.1 Zr 0.1 O 2 (M=Cr, Sn, Fe, Co, Ni, Mn, Cu) Catalyst in the Selective Catalytic Reduction of NO by CO**

Mnox/Ceo2/Sio2 Catalysts Prepared by Adsorption Phase Reaction Technique for Selective Catalytic Reduction of Nox at Low-Temperature

Co Single Atoms and CoOx Nanoclusters Anchored on Ce0.75Zr0.25O2 Synergistically Boosts the NO Reduction by CO

Investigation of the NO removal by CO on CuO–CoOx binary metal oxides supported on Ce0.67Zr0.33O2

A Study of CuO/CeO2/Al–Zr–O in “NO + CO”

Cu-ZSM-5 Catalyst Impregnated with Mn–Co Oxide for the Selected Catalytic Reduction of NO: Physicochemical Property–Catalytic Activity Relationship and In Situ DRIFTS Study for the Reaction Mechanism

Comparative study of 3D ordered macroporous Ce0.75Zr0.2M0.05O2−δ (M = Fe, Cu, Mn, Co) for selective catalytic reduction of NO with NH3

High-Performance Strategy and Degradation Mechanism of Cezrvox Catalysts for Nox Reduction

Effect of MnO(x) Modification on the Activity and Adsorption of CuO/Ce(0.67)Zr(0.33)O(2) Catalyst for NO Reduction.

Comparative Study Of 3d Ordered Macroporous Ce0.75zr0.2m0.05o2-Delta (M = Fe, Cu, Mn, Co) For Selective Catalytic Reduction Of No With Nh3

Interfacial effects promote the catalytic performance of CuCoO2-CeO2 metal oxides for the selective reduction of NO by CO

The structure of CuO-ZrO2 mixed oxides and its influence on the catalytic selective reduction of NO by propene

Morphology-Dependent Properties of MnOx/ZrO2–CeO2 Nanostructures for the Selective Catalytic Reduction of NO with NH3

Nickel foam supported CuCe mixed metal oxide as monolith catalyst for NO removal

Hollow Mn-doped CeO2@Co3O4 catalyst for NO reduction by CO

Investigation of Co–Mn–Ce Ternary Composite Oxide Catalyst for Low-Temperature Selective Catalytic Reduction of NOx with NH3

The reduction of copper in LaFeO3, La2CuO4 and CuO three-phase system improves the efficiency of NO removal: Experimental and density functional theory calculation

Insights into the highly activity CuMgFe oxides for the selective catalytic reduction of NO by CO: Structure-activity relationships and K/SO2 poisoning mechanism

Crystal facet-modulated CuO/CeO 2 catalysts for highly selective catalytic reduction of NO by CO

Study on the performance of magnetic Co3O4/γ-Fe2O3 catalyst in NO + CO reaction

Bifunctional Catalyst of CuMn-HZSM-5 for Selective Catalytic Reduction of NO and CO Oxidation under Oxygen Atmosphere