Abstract:The theoretical analysis reveals that there is a contradiction between the optimum embedding impedance of the diode and the matching circuit. They have opposite trajectory directions on the Smith chart with frequency, limiting the bandwidth of frequency multipliers. Under this constraint, an impedance compression matching technique (ICMT) is proposed in this paper, which is demonstrated to be helpful to realize broadband design of terahertz frequency multipliers. In this paper, the bandwidth limitations of frequency multipliers are analyzed theoretically in terms of maximum power transmission. The analysis shows that due to conjugate with the impedance of the diode itself, the optimum embedded impedance of the diode possesses a counterclockwise impedance trajectory versus frequency on the Smith chart, whereas the matching circuit exhibits a clockwise impedance trajectory versus frequency on the Smith chart. Under this constraint, an impedance compression matching technique (ICMT) is proposed to realize broadband design for terahertz frequency multipliers. Based on the proposed design method, a 170‐ to 260‐GHz full‐band frequency doubler was designed, fabricated, and measured. The measured results show that the doubler achieves an output power of 4–7.5 mW in the entire frequency band under 140‐mW input power, corresponding to a conversion loss of 12.5–15.4 dB.

An 8.3% Efficiency 96–134 GHz CMOS Frequency Doubler Using Distributed Amplifier and Nonlinear Transmission Line

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

Ultralow Power K-Band Frequency Doubler with Differential Output

A Wideband CMOS Frequency Quadrupler with Transformer-Based Tail Feedback Loop.

A Three Stage, Fully Differential 128–157 GHz CMOS Amplifier with Wide Band Matching

A compact, fully differential D-band CMOS amplifier in 65nm CMOS

Optimally Matched 189-232 GHz 6.8 dBm Output Power CMOS Frequency Doubler

A Balanced Frequency Doubler Covering 140-220 GHz With an Efficiency of 6.8%-11.6%

A 26-38GHz Ultra-Wideband Balanced Frequency Doubler in 0.15µ m GaAs pHEMT Process

A 39 GHz–80 GHz Millimeter-Wave Frequency Doubler with Low Power Consumption in 65nm CMOS Tehnology

A Novel Four-Port Configuration With Improved Efficiency and Power-Handling Capability for Diode-Based Doublers in Submillimeter Waves

An Amplifier-Doubler Chain with Conversion Gain Improvement Techniques

A 5.1 Dbm 127–162 GHz Frequency Sextupler with Broadband Compensated Transformer-Based Baluns in 22nm FD-SOI CMOS

A Novel Architecture for Frequency Doubler Featuring Compact 3-D Stacked Packaging and Four Multiplying Structures

A Frequency Doubler With Second Harmonic Feedback for Wideband, Efficient Frequency Multiplication at Millimeter-Wave

A Compact 24.5–32.6 GHz CMOS Frequency Doubler Based On Coupled Inductor

A 170‐ to 260‐GHz Full‐Band Frequency Doubler Realized by Impedance Compression Matching Technique

A Novel Transformer-Based Mm-Wave Frequency Doubler with Enhanced Output Symmetry

A 91.9-113.2 GHz Compact Frequency Tripler with 44.6 dBc Peak Fundamental Harmonic-Rejection-Ratio Using Embedded Notch-filters and Area-Efficient Matching Network in 65 nm CMOS

A 94-GHz Frequency Doubler in Nano-Scale CMOS Technology for W -Band Millimeter Wave Passive Imaging Systems

A 28-Ghz Power Amplifier with Enhanced Back-Off Efficiency Based on 65-Nm CMOS Process