Abstract:As a result of a collaboration between Jefferson Lab and niobium manufacturer CBMM, ingot niobium was explored as a possible material for superconducting radiofrequency (SRF) cavity fabrication. The first single cell cavity from large grain high purity niobium was fabricated and successfully tested at Jefferson Lab in 2004. This pioneering work triggered research activities in other SRF laboratories around the world. Large grain niobium became not only an interesting alternative material for cavity builders, but also material scientists and surface scientists were eager to participate in the development of this material. Most of the original expectations for this material of being less costly and allowing less expensive fabrication and treatment procedures at the same performance levels in cavities have been met. Many single cell cavities made from material of different suppliers have been tested successfully and several multi-cell cavities have shown the performances comparable to the best cavities made from standard poly-crystalline niobium. Several 9-cell cavities fabricated by Research Instruments and tested at DESY exceeded the best performing fine grain cavities with a record accelerating gradient of Eacc = 45.6 MV/m. Recently- at JLab- by using a new furnace treatment procedure a single cell cavity made of ingot niobium performed at a remarkably high Q0-value (~5x10^10) at an accelerating gradient of ~20 MV/m, at 2K. Such performance levels push the state-of-the art of SRF technology to new limits and are of great interest for future accelerators. This contribution reviews the development of ingot niobium technology and attempts to make a case for this material being the choice for future accelerators.

Nb Sputtered 325 MHz QWR Cavities for CIADS

Demonstration of Niobium Tin in 218 MHz Low-beta Quarter Wave Accelerator Cavity

R&d on the niobium-copper superconducting cavity

Studies on the Improvement of Niobium-Sputtered Quarter Wave Resonator Superconducting Cavity

First Results from Nb3Sn Coatings of 2.6 GHz Nb SRF Cavities Using DC Cylindrical Magnetron Sputtering System

Research and experiments on niobium-sputtered superconducting QWR in Peking University

Researches And Preliminary Experiments On Copper-Niobium Sputtered Low-Beta Superconducting Resonator

Niobium coaxial cavities with internal quality factors exceeding 1.5 billion for circuit quantum electrodynamics

Enhanced radio-frequency performance of niobium films on copper substrates deposited by high power impulse magnetron sputtering

The Rise of Ingot Niobium as a Material for Superconducting Radiofrequency Accelerating Cavities

R&D OF NIOBIUM-SPUTTERED COPPER QWR FOR HEAVY ION LINAC IN PEKING UNIVERSITY

RESEARCHES AND EXPERIMENTS ON NIOBIUM-SPUTTERED SUPERCONDUCTING QWR IN PEKING UNIVERSITY

Commissioning of Dedicated Furnace for Nb3Sn Coatings of 2.6 GHz Single Cell Cavities

A Path to Higher Q0 with Large Grain Niobium Cavities

Analysis of RF losses and material characterization of samples removed from a Nb3Sn-coated superconducting RF cavity

MgB$_{2}$ Coating by HPCVD for 1.3-GHz Superconducting RF Cavities

SUPERCONDUCTING TESTS AND BEAM LOAD EXPERIMENTS ON NIOBIUM-COATED COPPER QWR AT PKU

Study on laser annealing of niobium films deposited on copper for RF superconducting cavities

Influence of material parameters on the performance of niobium based superconducting RF cavities

Understanding and optimization of the coating process of the radio-frequency Nb 3 Sn thin film superconducting cavities using tin vapor diffusion method

Nb3Sn multicell cavity coating system at JLAB